Reina - Logo

INSTALLATION GUIDE
Radiator x1

This product must be fitted only by a fully qualified installer.Reina RNDETH1250C Eltham Designer Towel Rail - Cover

RNDETH1250C Eltham Designer Towel Rail

Reina RNDETH1250C Eltham Designer Towel Rail - Product Overview 1

DESCRIPTION ILLUSTRATION
Fixing choose the appropriate fixing for the wall material if required Reina RNDETH1250C Eltham Designer Towel Rail - icon 1
PTFE tape Reina RNDETH1250C Eltham Designer Towel Rail - icon 2
Electric drill Reina RNDETH1250C Eltham Designer Towel Rail - icon 3
Masonry drill bit approplate to the fixings Reina RNDETH1250C Eltham Designer Towel Rail - icon 4
Adjustable spanner Reina RNDETH1250C Eltham Designer Towel Rail - icon 5
Radiator valve hex key Reina RNDETH1250C Eltham Designer Towel Rail - icon 6
Flat head and philips head screw drivers Reina RNDETH1250C Eltham Designer Towel Rail - icon 7
1 lock shield valve and 1 gate or thermostatic valve Reina RNDETH1250C Eltham Designer Towel Rail - icon 8
Spirit level Reina RNDETH1250C Eltham Designer Towel Rail - icon 9
Measuring tape Reina RNDETH1250C Eltham Designer Towel Rail - icon 10

Reina RNDETH1250C Eltham Designer Towel Rail - Product Overview 2

A The radiator should not be mounted closer than 50mm below any overhanging surface (i.ei shelf) and no lower than 100mm from the floor. Transfer the bracket drill position measurements to the wall.
B Drill the wall and insert wall anchors (1) (or other suitable fixings).
C Put the brackets (2) on the wall and screw them to the wall anchors (1) with fixing screws (4).
D Insert Radiator (5) into the brackets (2) and tighten the security screws (3)

GENERAL RECOMMENDATION

  • Before fitting the radiator it is necessary to wash out the heating system to remove any existing mud, scale, work residues, traces of flux, oil, etc.
  • When the system water pH is outside the 5,5-8,5 range and/or when the dissolved is above 0,1mg/litre, it is always needed to protect the heating system components (the radiator is one of these) with a proper chemical treatment compatible with all parts in contact with water (silicon rubber too).
  • In order to fit the radiator to the wall, it is necessary to choose the proper fixings for the wall material.
  • If the system water exceeds 50°C, please install a warning mark near the radiator to avoid any accidental scalding.
  • Clean the radiator surface only with a soft cloth to avoid scratching the finish and do not use chemical against during cleaning operations. It is prohibited to climb on the radiator.
  • Maximum working temperature 95°C, maximum working pressure 4 bar.

Documents / Resources

Reina RNDETH1250C Eltham Designer Towel Rail [pdf] Installation Guide
RNDETH1250C Eltham Designer Towel Rail, RNDETH1250C, Eltham Designer Towel Rail, Designer Towel Rail, Towel Rail, Rail

References

Leave a comment

Your email address will not be published. Required fields are marked *