REGENCY Mobile Ice Bin Instruction Manual

The Mobile Ice Bin is a versatile and sturdy product designed to securely hold and transport ice. It consists of the following parts:

• A (1) Ice Bucket
• B (4) Tube Legs
• C (4) Joint Sockets
• D (2) Long Section Cross Brace
• E (2) Short Section Cross Brace
• F (2) Wheel with Brake
• G (2) Wheel without Brake
• H (20) Set Screws

This ice bin is made with stainless steel edges, so it is important to handle it with care to avoid any cuts. It is recommended to wear gloves during installation.

1. Insert the tube legs into the leg gussets.
2. Tighten the set screws to secure the legs in place.
3. Connect the cross braces with the joint sockets.
4. Loosely tighten the set screws on the joint sockets for now. Full tightening will be done later.
5. Place the ice bin legs into the vertical section of the joint socket.
6. Fully tighten the set screws on the joint sockets to secure the legs and braces.
7. Slide the casters into the bottom of the tube legs.

WARNING! There is a risk of personal injury due to sharp stainless steel edges. Please wear gloves during installation and handle the product with care.

For more information and support, please visit www.RegencyTablesandSinks.com.