RDX Standard Wall Bracket Instruction Manual

RDX Standard Wall Bracket

TOOLS REQUIRED

10mm Masonry Drill belt
10mm Spanner or Socket
Plastic/ Wooden Mallet

Parts List

• M8 x 65 Hex Bolt x 3
• M10 x 50 Nylon Plug x 3
• 25 x 25 End Cap x 1
• 22 x 22 End Cap x 2
• 8mm Dee-Shackle x 1

Installation

• Follow the diagram to fix your bracket to either a brick/stone wall.
• Use a mallet to insert C & D.
• Drill hole 65 mm deep to insert B.
• Ensure all bolts are tightened.

Disclaimer

Make sure to assemble this product according to the instructions. Failure to do so might translate into harmful consequences. Make sure that the weight of the equipment doesn’t exceed the weight of the capacity of this product. If you lack of the necessary expertise to attach this product to the wall structure that you are using . Contact a construction professional to install the wall mount or to provide specific mounting instructions for your wall structure. Bracket must be fixed to a solid surface not to a cavity or plaster board wall.