RDR8000V Professional Digital Two-Way Radio Repeater
“
Specifications:
- Device Type: Land Mobile Radio
- Intended Use: Occupational
- Compliance: FCC and International Standards
- Authorized Use: Occupational/Controlled Conditions
Product Information:
This device is a Land Mobile Radio intended for occupational use
only. It is designed to operate within established RF exposure
limits and compliance standards set by the FCC and International
regulations. Users are required to have full knowledge of RF energy
exposure and control measures to ensure safe usage.
Usage Instructions:
Safety Information:
Before using the device, it is crucial to read the RF Energy
Exposures and Product Safety Guide provided by RCA Communications
Systems. This guide contains important operating instructions for
safe usage, RF energy awareness, and compliance with applicable
standards and regulations.
RF Exposure Awareness and Control:
This device is authorized for use in occupational/controlled
conditions where users can control their exposure to meet
occupational limits. It is not intended for general population
consumer use.
Compliance Guidelines:
To maintain compliance with RF exposure limits, it is essential
to use only RCA Communications Systems approved antennas, supplied
or replacement antennas, and accessories. For a list of approved
accessories, refer to the user manual or visit the official
website.
Additional Resources:
For more information on RF energy exposure and compliance, visit
the following websites: FCC (United
States) | ISED
(Canada)
FAQ:
Q: Can this device be used by the general population?
A: No, this device is restricted to occupational use only where
users can control their exposure to meet established limits.
Q: Where can I find more information on RF energy
exposure?
A: You can visit the FCC website for information in the United
States and the ISED website in Canada.
“`
RF Exposure / Compliance Information
FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
WARNING: Under ISED regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by ISED. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. The transmitter antenna gain shall not exceed 0 dBi for both US and Canada market. FRENCH: Conformément à la réglementation d’ISED, le présent émetteur radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par ISED. Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée quivalente (p.i.r.e.) ne dépassepas l’intensité nécessaire à l’établissement d’une communication satisfaisante. Le gain de l’antenne émettrice ne doit pas dépasser 0 dBi pour les marchés américains et canadiens.
Please refer to the following websites for more information on what RF energy exposure is and how to control your exposure to assure compliance with established RF exposure limits. http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf01904.html http:// www.ic.gc.ca/eic/site/ceb-bhst.nsf/eng/h_tt00080.html
Important Safety Information Attention: This device is restricted to Occupational use only. Before using the device, read the RF Energy Exposures and Product Safety Guide for Land Mobile Radios which contains important operating instructions for safe usage and RF energy awareness and control for Compliance with applicable standards and Regulations.
www.RCACommunicationsSystems.com
RF Energy Exposure Awareness and Control Information and Operational Instructions for Occupational Use
NOTICE: This device is intended for use in occupational/controlled conditions where users have full knowledge of their exposure and can exercise control over their exposure to meet the occupational limits in FCC and International standards. This device is NOT authorized for general population consumer use.
RF Exposure Compliance and Control Guidelines and Operating Instructions
To control your exposure and ensure compliance with the occupational/controlled environment exposure limits always adhere to the following procedures. Guidelines: · Do not remove the RF Exposure Label from the device. · User awareness instructions should accompany device when transferred to
other users. · Do not use this device if the operational requirements described herein are
not met.
Operating Instructions: · This equipment complies with FCC / ISED radiation exposure limits set forth for a
controlled environment. This equipment should be installed and operated with minimum distance of 0.8 meters/80cm (2.6 ft.) between the radiator and nearby persons. · This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. · DO NOT hold the antenna when the device is transmitting. · DO NOT use the device that has a damaged antenna. If a damaged antenna comes into contact with your skin, it can result in a burn.
To ensure continued compliance with applicable RF exposure limits, use only RCA Communications Systems approved, supplied or replacement antennas, and accessories. For a list of RCA approved accessories please refer to your user manual or visit www.rcacommunicationssystems.com
EXPOSURE RF compliance et Lignes de contrôle et Instructions opérationnelles
Pour contrôler votre exposition et assurer la conformité avec le milieu ambiant, il est toujours nécessaire de suivre les procédures suivies. Taliban: · On ne peut pas enlever le Label RF de ce dispositif. · L’utilisateur doit utiliser le dispositif de référence pour les autres utilisateurs.
· Il ne faut pas utiliser cet appareil pour les besoins opérationnels. Description
des opérations: · L’appareil est conforme aux limites d’exposition aux rayonnements spécifiées par la FCC/ ISED pour les environnements contrôle. Cet équipement doit être installé et utilisé en respectant une distance minimale de 0,8 mètres/80 cm (2,6 ft.) entre le radiateur et les personnes à proximité. · Cet émetteur ne doit pas coexister ou fonctionner conjointement avec toute autre antenne ou émetteur. · NE TENEZ PAS l’antenne entre vos doigts pendant que la radio émet. · N’UTILISEZ PAS une radio portative, quelle qu’elle soit, dont l’antenne est endommagée. Si une antenne endommagée entre en contact avec votre peau, il peut en résulter une brûlure légère.
Pour assurer la conformité continue avec les limites d’exposition aux RF applicables, utilisez uniquement les antennes, et les accessoires de remplacement ou fournis et approuvés par RCA Communications Systems. Pour obtenir une liste des accessoires approuvés par RCA Communications Systems, veuillez consulter votre manuel ou visitez le site www.rcacommunicationssystems.com.
For more information on what RF energy exposure is, see the following websites: https://www.fcc.gov/ (United States) | https://ised-isde.canada.ca/ (Canada)
*FCC refers to Federal Communications Commission *ISED refers to Innovation, Science, and Economic Development Canada
RCA, the RCA logo and the two dogs (Nipper and Chipper) are trademarks used under license. For further information visit www.rca-brand.com. All other trademarks are the property of their respective owners. © 2025 RCA Communications Systems. All rights reserved. For more information about this product visit www.rcacommunicationssystems.com.
Documents / Resources
 |
RCA RDR8000V Professional Digital Two-Way Radio Repeater [pdf] User Guide XYH-RDR8000V, XYHRDR8000V, rdr8000v, RDR8000V Professional Digital Two-Way Radio Repeater, RDR8000V, Professional Digital Two-Way Radio Repeater, Digital Two-Way Radio Repeater, Two-Way Radio Repeater, Radio Repeater, Repeater |