Boost Static Return Frame
Instruction Manual
Component parts
| NO. | Component Name | PCS |
| 1 | Table feet | 1 |
| 2 | Column | 1 |
| 3 | Bolt: M6x12 | 2 |
| 4 | Screw:ST4x20 | 13 |
| 5 | Side brackets | 1 |
| 6 | Rubber pad | 10 |
| 7 | Top frame-1 | 1 |
| 8 | Bolt: M6x10 | 3 |
| 9 | Centre bracket | 1 |
| 10 | Center rails | 2 |
| 11 | Top frame-2 | 1 |
| 12 | Hand bolts M6x10 | 2 |
| 13 | Allen Wrench(4mm) | 1 |
| 14 | Allen Wrench(5mm) | 1 |
| 15 | Cable tie | 2 |
Assembly Instructions
Step 1
Loosen the pre-installed bolts and Adjust the length of the top frame to match the size of the table top.
Step 2
Inset the Column to the top frame,fix lifting column with 4pcs screws M6x12 like.
Step 3
Place the table feet on the column and rotate it and make it align, then tighten the pre-installed bolt.
Step 4
Place the side bracket on the top frame and tighten the bolts.
Step 5
Connect the return frame to the single workstation and fixed with 2 hand bolts.
Fix the centre brackets with 2pcs screws M6x10.
Step 6
Mount the tabletop and fix it with24 pcs screws ST4x20;
Fix the centre bracket with 2 pcs screws M6x10
Cable tray installation
Step 1
– Fix the cable tray(B2-SSCT ) to the cable tray arms(B2-SSARM) with 8 pcs M6x10 screws.
Step 2
– Install the U brackets to the desk frame with 4 pcs M8x10 screws.
– Mount the cable tray to the desk frame and fix it with 6 pcs M6x10 screws
Screen panel installation ( Shush30 Privacy Screen )
Step 1
– Insert the tapped plates to the screen panel ( plates can be found in B2-SBRAC carton )
Step 2
– Install the screen brackets ( B2-SBRAC )to the Shush30 Extrusion with 8 pcs M5x6 screws.
Step 3
– Fix the screen brackets ( B2-SBRAC ) to the desk frame with 10 pcs M6x10 screws.
EPS ( 900mm H Eco Panel ) Screen panel installation
Step 1
– Install the screen brackets(B2-SBRAC) on the cable tray arm (B2-SSARM)with 10 PCS M6x10 Screws The brackets direction as photos display.
Step 2
– Place the EPS panel on the screen brackets
Using a 6mm drill bit ( not included ), drill out holes in Eco Panel Screen in line with back to back screen bracket holes ( Note: Carbide Drill Bits Work Best For PET panel )
– Place 8 x Double Ended Bolts M5* 32mm – 6mm through The screen bracket ( B2-SBRAC ) holes and the holes you have created in the Eco Panel Screen. Tighten double ended bolt with Allen key.
Documents / Resources
 |
Rapidline SB-RF1021 Boost Static Return Frame [pdf] Instruction Manual SB-RF1021, SB-S18, SB-RF1021 Boost Static Return Frame, SB-RF1021, Boost Static Return Frame, Static Return Frame, Return Frame, Frame |