ESP-TM2 Controller
User Guide
ESP-TM2 Controller
ESP-TM2 Controller Quick Start
Controls
Set Date and Time
Manual Watering
TEST ALL STATIONS
RUN A SINGLE STATION
To begin manual watering, hold or turn dial to auto run
Programming Overview
STEPS REQUIRED FOR IRRIGATION
- Select a program
- Set watering start times
- Set station run times
- Set watering run days-custom days
SELECT A PROGRAM Press program select button to choose program A, B or C for set up.
SET WATERING START TIME
SET STATION RUN TIME
SETWATERING RUN DAYS
*To set odd/ even or cyclic run days, see page 14of~ser manual 
ESP-TM2 Controller Programming Chart
http://www.rainbird.com/esptm2
Call Rain Bird toll free
Technical Support at
1-800-724-6247
(USA and Canada only)
Documents / Resources
 | ESP-TM2 Controller |
References
- Manual-Hub.com - Free English product PDF Documents!manual-hub.com
- User Manualmanual.tools
Published: January 26, 2024
Updated: January 27, 2024
Merhaba 4 adet seldnoid vana var başlangıç saati aynı 4 ünüde 00.15 yapıyorum 4 istasyon arka arkaya çalışıyor bitince yeniden 3 kez daha arka arkaya çalışıyor yani 3 kez fazladan nasıl ayarlamam lazım
Why is my Rain Bird ESP-TM2 controller running the same watering cycle 4 times in a row?
The reason your system is running 4 times in a row is likely because you have set four different Watering Start Times for the same program. On the Rain Bird ESP-TM2, you only need to set one start time for the entire program to run all stations (valves) in sequence.
To fix this, follow these steps:
Once only the 1st Start Time is set, the controller will start at 00:15, run Station 1, then Station 2, then Station 3, and finally Station 4, and then stop.
Read the full Q&A page