Quick WCS 820 Windlass Control Board

DRAWING OF ASSEMBLY

Proceed with installation following the numbering of the elements.

1. Shunting switch
2. Plastic washer
3. Anti-rotation washer
4. Neoprene gasket
5. Control plate
6. 4 self-tapping screws
7. WCS 820 label
8. Black shunting switch protective cap
   • 7c
     Remove the transparent protective film. Retirez le film protecteur transparent. Retire la película protectora transparente. Die transparente Schutzfolie entfernen.
   • 7a) Remove the protective paper from the back of the label.
     For a better seal, avoid touching the adhesive part with your fingers. Clean the surface of the control plate (5) before applying.
     WARNING: it is recommended not to apply the adhesive on the control plate (5) at temperatures below 18° C.
   • 7b) To apply the label properly, we recommend placing one side against the edge of the control plate (5) first and then completing the application. Press the entire surface firmly to make it stick well.

Installation and use of manual
WINDLASS CONTROL BOARD (UP/DOWN)
Electric device enabling windlass operation even in the rudder area.

DIMENSION

WIRING DIAGRAM

Documents / Resources

Quick WCS 820 Windlass Control Board [pdf] User Manual WCS 820, Windlass Control Board, WCS 820 Windlass Control Board, Control Board, Board

References

• User Manual