Quantek TS-SQ-SG Proximity Switch for Activation and Access Control Instruction Manual
Installation:
Ascertain fixing height. Use the box to mark the four fixing points.
Use knockout and place cable through if hardwiring.
Fit seal to back of box if being used externally (Square only), and secure box to the wall with 4 x No8 (4mm) screws.
Make connections (see below, do not leave excessive cable in the back box), or connect battery clip and place battery holder in the marked compartment, then program into the receiver (see next page)
Place signage plate back into the box and insert the two screws.
Do not over tighten screws!
Hardwired specification:
12 – 28Vdc
8mA (standby) / 35mA (max)
+18mA LEDs
Sensitivity – Touch – up to 70mm
Selectable red, green, blue LEDs
Sounder on activation
Timer 1 – 27 seconds
Latching function
Wiring diagrams
Hardwired sensor wiring. Alter LED colour configuration as required.
Note: Never connect anything to RD terminal
If using a square illuminated unit, connect the LED wires to the terminals marked on the large outer LED panel PCB, instead of the touch sensor PCB
Radio programming (RX-2 receiver)
Supply receiver with 12/24Vdc power. +V to 12/24V terminal, -V to GND terminal. LED will light if powered correctly
Wire relay outputs to activate terminals on the system (clean, normally open contacts)
Press and release the learn button, the learn LED will light up for 10 seconds
Within the 10 seconds operate the touch sensor
The learn LED will flash to confirm it has programmed
Note: Touch sensors program to channel 1. The RX‐T receiver will be required if you need to program them to different channels.
It is also possible to program our handheld and desk mount transmitters (CFOB, FOB1-M, FOB2‐M, FOB2-MS, FOB4‐ M, FOB4-MS, DDA1, DDA2) into this receiver using the same method. See transmitter box for more details.
Reset: To reset the receiver, press and hold the learn button for 10 seconds until the learn LED starts flashing. After this the memory will be deleted.
Radio specification
868MHz
4 x AA batteries (Square)
4 x AAA batteries (SG)
Approximately 100,000 operations
Sounder & green LED on activation
Battery saving design, unit will only activate once if hand left on
Receiver specification
12/24Vdc supply
868MHz
2 channels
1A 24Vdc normally open contacts
Momentary/bi‐stable selectable relays
200 code memory
Dimensions: 65 x 50 x 30 mm
Programming video
https://www.youtube.com/watch?v=oqcPXfnqKvc
Note:
Matching screw cover stickers are supplied as an optional feature for aesthetic purposes.
If required, they should be affixed after the unit has been installed. To affix them, simply peel off the yellow adhesive backing and stick them over the two screws. They can be easily removed with a knife for battery changes.
Spares are may also be supplied, these should be left inside the unit.
Documents / Resources
 |
Quantek TS-SQ-SG Proximity Switch for Activation and Access Control [pdf] Instruction Manual TS-SQ-SG Proximity Switch for Activation and Access Control, TS-SQ-SG, Proximity Switch for Activation and Access Control, for Activation and Access Control, and Access Control, Access Control |