QUAD LOCK 360 Suction Base

Instructions for Suction Base Assembly
The diagram illustrates the assembly instructions for a suction base. Below are the steps described in the image:
Specifications
| Component | Description |
|---|---|
| BASE | The base of the device that will be attached to a surface using suction. |
| Suction Lever | Lever used to create suction and secure the base to a surface. |
| Locking Cogs | Circular components that lock the lever in place. |
Assembly Instructions
- Position the BASE on the desired surface.
- Press down on the BASE firmly to ensure it is flat and secure.
- Rotate the suction lever downwards to create suction and lock the BASE in place.
BASE SUCTION BASE

Additional Information
The diagram shows a hand pressing down on the BASE. Circular locking cogs are visible, indicating where the suction lever will engage. A symbol with a clockwise arrow indicates the direction in which the suction lever should be rotated to create the suction necessary to secure the BASE.
The bottom part of the image includes an icon indicating the manual, represented by a book and a wrench, suggesting that further instructions or tools may be available for the assembly or maintenance of the product. Additionally, there is a symbol representing a trash bin crossed out, indicating that the product should not be disposed of with regular waste, likely due to recycling or special disposal requirements for its components.
FAQ
How do I know if the BASE is properly secured?
Can the suction base be repositioned?
What surfaces are suitable for the suction base?
Documents / Resources
![]() | 360 Suction Base |
References
- User Manualmanual.tools

