QOMO-logoOPS PC Module

QOMO-OPS-PC-Module-product
Unpacking

Before use, make sure the following items are included in the package. If anything is missing, contact the retailer where you purchased the product.

QOMO-OPS-PC-Module-fig- (1)

  1. OPS PC Module x1
    QOMO-OPS-PC-Module-fig- (2)
  2. Antenna x2
    QOMO-OPS-PC-Module-fig- (3)
  3. Quick Start Guide x1

Install OPS PC Module

  1. Ensure the interactive screen is powered off.
  2. Remove the connector plate on the back side of the interactive screen and expose the connector.QOMO-OPS-PC-Module-fig- (4)
  3. Insert the OPS into the slot.
    QOMO-OPS-PC-Module-fig- (5)
  4. Tighten screws to permanently fix the computer to an interactive display.QOMO-OPS-PC-Module-fig- (6)
  5. Install the antenna on the OPS.
  6. Power on the display and proceed with Windows setup.

www.qomo.com
1-866-990-7666
support@qomo.com

Documents / Resources

QOMO OPS PC Module [pdf] User Guide
OPS PC Module, PC Module, Module

References

Leave a comment

Your email address will not be published. Required fields are marked *