Soundpeats Truengine SE User Manual — questions & answers

If your Soundpeats Truengine SE earbuds have a volume imbalance (one side louder than the other), it is often caused by a software synchronization…

The Soundpeats Truengine 3 SE (and the standard Truengine SE) does not support multipoint connection, meaning it cannot be actively connected to two devices,…

You are correct. While the original Soundpeats Truengine SE manual (the page you are currently on) may list different button controls, the Soundpeats Truengine…

If your laptop is unable to find the Soundpeats Truengine SE, it is likely because the earbuds are not in pairing mode or are…

To reset your Soundpeats Truengine SE earbuds and restore the connection between both units, follow these steps: Clear Pairing History: Go to your device's…

To return to stereo mode after using the earbuds in mono mode, you should first try taking both earbuds out of the charging case…

If your right earbud is not being detected even after a reset, please try the following steps to ensure the reset was successful and…

If your Soundpeats Truengine SE earbuds are not working together even after a reset, please follow these specific steps to ensure they re-pair with…

If your Soundpeats Truengine SE earbuds remain connected and continue playing music while inside the case, it usually indicates that the earbuds are not…

If your PC recognizes the Soundpeats Truengine SE as headphones but not as a microphone, it is often due to how Windows manages Bluetooth…

Volume imbalance between earbuds can often be resolved by performing a factory reset or checking for physical obstructions. Follow these steps to troubleshoot your…

If the audio in your right earbud is quieter than the left, please try the following troubleshooting steps for your Soundpeats Truengine SE: Clean…

If your left earbud is not connecting or charging, please try the following troubleshooting steps based on the Soundpeats Truengine SE manual: Check Charging…

If your Soundpeats Truengine SE earbuds are disconnecting from your TV or Bluetooth adapter shortly after pairing, it is often due to a pairing…

Rapid blinking usually indicates that the earbuds are having trouble syncing with each other or are stuck in a specific state. To resolve this,…

If the right earbud of your Soundpeats Truengine SE is not responding to touch commands for volume control, please try the following troubleshooting steps:…

If your Soundpeats Truengine SE earbuds are not entering pairing mode (no "pairing" voice prompt) and are not appearing on your phone's Bluetooth list…

If the left touch control (multifunction button) is unresponsive, performing a standard factory reset is difficult because the process requires holding both buttons simultaneously.…

The rapid blinking white light typically indicates that the earbuds are struggling to pair with each other or your device. To resolve this, you…

To fix a Soundpeats Truengine SE earbud that is flashing white quickly or failing to connect, you should perform a factory reset. According to…