COREMORROW questions & answers

To discharge the N56 piezo motor before installation, you can achieve this by connecting it to the controller. The controller will handle the discharge…

To discharge the N61.R5E/K piezo motor before installation, you can achieve this by connecting it to the controller. The controller will help discharge the…

To properly install the ZT50M14 piezo actuator for cage structure, please follow these steps: 1. Ensure that the installation plane is flat. 2. Secure…

To discharge the N61.R5E/K-C1 piezo motor before installation, you can achieve this by connecting it to the controller. The controller will handle the discharge…

To connect the XD700.100S-B Piezo Actuator to the controller, please follow the installation and connection instructions provided in the user manual. Here are the…

To connect and operate the COREMORROW E53.C4K Piezo Motor Controller, please follow the instructions provided in the user manual. Here is a step-by-step guide:…

To connect the COREMORROW E53.D1E-J/E53.C1K-J Piezo Motor Controller to your computer, follow these steps: 1. Locate the USB port on the controller. It is…

To connect the COREMORROW E71.D4E-H Piezo Motor Servo Controller to a power supply, follow these steps: 1. Make sure the power supply is within…

To properly install and mount the load on the COREMORROW S51.ZT1S/K-C1 Piezo Z/Tip/Tilt Platform, please follow these steps: 1. Ensure that the load quality…

To connect and power the COREMORROW E63.A1K Series Piezo Controller, follow these steps: 1. Connect the power supply: Use a +15VDC/0.5A power supply and…

To connect the E51.D7S Piezo Controller to a computer or other device, you will need to use the RS-422 interface. Here are the steps…

To connect the E51.D12S series piezo controller to your computer for control, you can use either the USB interface or the RS-232/422 interface socket.…

To connect the COREMORROW E51.B3S Series Piezo Controller to a power supply, follow these steps: 1. Make sure the power supply is compatible with…

To discharge the P11 piezo nanopositioning stage before installation, you can follow the instructions provided in the user manual. Connect the piezo stage to…

To discharge the N31 Linear Piezo Motor before installation, you can achieve this by connecting it to the controller. The controller will handle the…

To properly install the S50.UR0C/K Piezo Tilt/Rotation Stage, please follow the steps outlined in the user manual: 1. Ensure that the installation plane is…

According to the user manual, it is advised not to connect or disconnect input, output, or sensor cables with the power on. To ensure…

To connect the S20 piezo rotation stage to the controller, follow these steps: 1. Identify the connector on the S20. The driving cable interface…

To connect the S22 piezo tip-tilt platform to the controller, please follow these steps: 1. Before installation, ensure that the cable is in good…

To discharge the P92 piezo stage before installation, you can connect it to the controller. The controller will discharge the piezo stage automatically. It…

To discharge the P70 piezoelectric nanopositioning scanner before installation, you need to connect it to the controller. This will effectively discharge the scanner. Please…

To properly install the COREMORROW P12 Piezo Nanopositioning Scanner, please follow these steps: 1. Ensure that the installation surface is flat and clean. 2.…

To discharge the XP-611 piezo nanopositioning stage before installation, you need to connect it to the controller. The controller will discharge the stage and…

To connect the S21 Piezo Rotation Stage to the controller, follow these steps: 1. Ensure that the S21 connector is properly identified on the…