How do I install the hard drive in the SPYCLOPS 120N16POE2 4K POE NVR?
To install the hard drive in the SPYCLOPS 120N16POE2 4K POE NVR, please follow these steps:
1. Disconnect all power before starting the installation.
2. Use a Phillips screwdriver to unscrew the screws on the back and sides of the chassis and remove the cover.
3. Connect one end of the hard disk power cable and SATA data cable to the motherboard and the other end to the hard disk.
4. Align the hard disk xxxx holes to the chassis backplane and then tighten the screws.
5. Install the cover and reattach it with screws.
Please note that it is recommended to use a surveillance-grade hard disk drive to avoid poor drive performance.
Answer this question
Answers are reviewed before publication.