How do I charge the Shiny Alice SN40449030-a-02 3D Printing USB Charging Moon Lamp?

To charge the Shiny Alice SN40449030-a-02 3D Printing USB Charging Moon Lamp, follow these steps:

1. Connect the lamp to a power source using the provided USB charging cable.
2. Insert one end of the USB cable into the charging port located on the bottom of the lamp.
3. Plug the other end of the USB cable into a USB port on your computer, a power bank, or a wall adapter.
4. Ensure that the power source is turned on and supplying power.
5. The lamp will start charging, and you will see a red indicator light on the lamp.
6. Allow the lamp to charge for approximately 2-3 hours or until the red indicator light turns off, indicating a full charge.
7. Once fully charged, disconnect the USB cable from the lamp and the power source.

Note: It is recommended to fully charge the lamp before initial use for optimal performance.