User Manual Q&AAnswer
Nov 27, 2025 - 02:51 PM
To adjust the recirculation flow rate on the ROCKER Tanfill 100 Flow Filtration System, follow these steps:
1. Make sure the machine is plugged into a power source and switched on.
2. Connect the sample tube to the machine's inlet port.
3. Add the desired samples to the liquid reservoir.
4. Locate the control or adjustment xxxx for the recirculation flow rate. This xxxx should be on the machine's control panel.
5. Turn the xxxx clockwise to increase the flow rate or counterclockwise to decrease it. Refer to the machine's manual for recommended flow rates based on your application.
6. Adjust the flow rate according to the desired concentration or diafiltration rate. You may need to monitor the process and make further adjustments as needed.
7. Monitor the pressure gauge to ensure that the system is functioning correctly while adjusting the flow rate.
8. Once the desired concentration or diafiltration is achieved, stop the machine and disconnect the sample tube.
9. Clean the machine thoroughly before storing it away.
By following these steps and referring to the product manual for specific guidance, you can effectively adjust the recirculation flow rate on the ROCKER Tanfill 100 Flow Filtration System to meet your filtration needs.
Add New Comment