User Manual Q&AAnswer
Nov 26, 2025 - 06:37 PM
To access the recorded data from the WSTHD-800-01-DS radio temperature and humidity sensor, you need to follow these steps:
1. **Connect to the Device**: The recorded data can be accessed by connecting to the device using the operating frequency of 868.4 MHz. This frequency is used to establish a communication link with the sensor.
2. **Use a Radio Recording Unit**: You will need a radio recording unit that is compatible with the sensor. This unit will allow you to retrieve the recorded data from the sensor.
3. **Install LOGGISOFT Software**: Ensure that the computer connected to the radio recording unit has the LOGGISOFT software installed. This software is necessary to read and interpret the data collected by the sensor.
4. **Read the Data**: Once the connection is established and the software is running, you can read the recorded temperature and humidity data from the sensor. The data will be displayed on the computer screen for analysis and monitoring.
By following these steps, you can effectively check and analyze the recorded data from the WSTHD-800-01-DS radio temperature and humidity sensor. If you encounter any difficulties or require further assistance, refer to the product manual or contact MIKSTER Sp. z o.o. at info@mikster.pl for support.
Add New Comment