How do I install the REL-EOL Releasing End Line Module with the additional diode for releasing applications using? (SIEMENS REL-EOL Releasing Module Instruction Manual)

Answer

manuals.plus

Oct 27, 2025 - 09:28 AM

To install the REL-EOL Releasing End Line Module with the additional diode for releasing applications using the CRM-4 and CSM-4, follow these steps as per the provided installation instructions:

1. **Diode Installation**: The REL-EOL module comes with one preinstalled diode and an additional diode for specific releasing applications. The additional diode is only used for releasing applications with the CRM-4 and CSM-4 modules. Refer to Figure 2 in the manual for the diode detail.

2. **End of Line Resistors**: The REL-EOL module also includes three end of line resistors that need to be field-installed based on the releasing module being used. Refer to the table in the manual for the resistor values and corresponding releasing modules.

3. **Wiring Instructions**: For specific wiring instructions, refer to the Releasing Installation Instructions provided in the manual. The manual lists different systems and their corresponding releasing modules along with the installation instructions for each system.

4. **Contact Information**: If you require further assistance or have specific questions regarding the installation or usage of the REL-EOL Releasing End Line Module, you can contact Siemens Industry, Inc. Building Technologies Division in Florham Park, NJ or Siemens Canada Limited Building Technologies Division in Brampton, Ontario.

By following the detailed instructions provided in the manual, you can successfully install and configure the REL-EOL Releasing End Line Module with the additional diode for releasing applications using the CRM-4 and CSM-4 modules.