User Manual Q&AAnswer
Jul 29, 2025 - 03:08 AM
To wire the DSE702 Generator Control Panel for manual start operation, follow these steps:
1. Low Oil Pressure Monitoring: Connect the low oil pressure sensor to the appropriate input terminal on the control panel. The control panel will monitor the oil pressure and trigger an alarm if it falls below the set threshold.
2. High Engine Temperature Monitoring: Wire the high engine temperature sensor to the designated input terminal on the control panel. The panel will monitor the engine temperature and alert you if it exceeds the specified limit.
3. Overspeed Monitoring: Connect the overspeed sensor to the corresponding input terminal on the control panel. The panel will monitor the engine speed and generate a warning if it goes beyond the preset threshold.
4. User-Defined Auxiliary Input: This input can be configured by the user for a specific monitoring or control function. Connect the desired sensor or signal to the auxiliary input terminal on the control panel.
5. Power Supply: Ensure the control panel is supplied with a continuous voltage within the range of 8 V to 35 V DC. The panel can withstand cranking dropouts and recover without the need for internal batteries.
6. Output Connections: The control panel provides solid-state output terminals for start, run, and pre-heat functions. Connect these terminals to the corresponding components in your generator system.
By following these wiring instructions and referring to the DSE702 Generator Control Panel user manual for specific details and diagrams, you can set up the control panel for manual start operation effectively.
Add New Comment