How do I pair the JLAB GO Air POP True Wireless Earbuds with my device?

To pair the JLAB GO Air POP True Wireless Earbuds with your device, follow these steps:

1. Remove the tab and close the door on the charging case.
2. The red light on the case indicates the charge. Remove the earbuds from the case.
3. One earbud will blink blue/white, indicating that it is ready to pair with your device.
4. On your device, go to the Bluetooth settings and select "JLab GO Air Pop" to connect.
5. You will hear a voice prompt saying "You're connected," followed by blinking white lights on the earbud, indicating that it is successfully connected to your device.

If you want to pair the earbuds with additional devices, follow these steps:

1. Turn off Bluetooth on any previously connected device.
2. Turn on Bluetooth on the new device.
3. Take the earbuds out of the case.
4. The earbuds will automatically enter Bluetooth pairing mode.
5. On the new device, go to the Bluetooth settings and select "JLab GO Air Pop" to connect.

Note: Only one Bluetooth device can be connected at a time. Make sure to turn off Bluetooth on unwanted devices and turn on Bluetooth on the chosen device to connect.

For more detailed instructions and troubleshooting tips, you can refer to the JLAB GO Air POP True Wireless Earbuds user guide provided above.