Q-TRAN DMX-US3 Controller for LED LightingINSTALLATION

1. Install the junction box into the wall.
2. Use a flathead screwdriver to pry the baseplate as shown:
3. Screw the baseplate to the junction box in the wall firmly.
4. Connect all components and put the power adapter into the junction box. Connect DMX GND to earth GND.
5. Snap the upper portion of the touch panel into the baseplate and then snap the bottom into place.
6. Connect to power supply.

sales@q-tran.com

www.q-tran.com

Documents / Resources

Q-TRAN DMX-US3 Controller for LED Lighting [pdf] Installation Guide DMX-US3 Controller for LED Lighting, DMX-US3, Controller for LED Lighting, LED Lighting, Controller

References

• User Manual