PLBAS82LE Active Dual Bass Subwoofer Box System
User Guide
PLBAS82LE Active Dual Bass Subwoofer Box System
WIRING CONNECTION
Power amplifier for schematic diagram.
- Positive pole: Connect +12V and Rem. in parallel
- Negative pole: connect to GND
REMOTE CONTROL FEATURES
- Turn ON/Standby: Press this key to turn on LEDs or switch to standby mode.
- 2/9. Dynamic Mode button: Switch from dynamic mode to color mode or switch between dynamic modes.
- 3/8. Dynamic Mode Speed button: Use these buttons to adjust dynamic mode speed. If the unit is in static mode, pressing these buttons will switch the unit to dynamic mode.
- 4/5. Static Color Adjust button: Use this button to swit h between static colors.
Pressing these keys while in dynamic mode will switch the unit to static mode. - 6/7. Brightness Adjust button: Pressing these buttons will adjust brightness while in static mode. If these buttons are pressed while the unit is in dynamic mode, it will switch to static mode.
- 10. Demo Mode button: This button will switch the unit into demo mode.
While in demo mode, the unit will loop through 9 of the dynamic modes with each repeating 3 times.
Features:
- Built-in Illuminating LED Lights
- Class-D Powered Enclosure Amplier
- Rear Vented Design
- High Powered 8-inch Woofers with a Silver Paper Cone
- Rubber Edge Suspension
- Smooth Carpet Finish
- 4 Layer Dual Voice Coil
- Binding Post Connectors
- Perfect for Truck and Behind the Seat
- High-Quality Construction
What’s in the Box:
- Subwoofer Box
- LED Remote Control
- Output Wire for Amplifier
PLBAS82LE 8”
Dual Bass Subwoofer Box System
Rear Vented Design with Built-in Illuminating LED Lights
Technical Specs:
- Construction Materials: 15mm Particle Board + Multilayer Board
- Power Rating: 2×400 Watts Max Power
- Voice Coil: 1.5”
- Impedance: 4 Ohms
- Magnet: 2×30 Oz
- Sensitivity: 90 dB
- Frequency Response: 40-1K Hz
- Remote Control Battery Operated, Requires (1) x ‘CR2025’ Batteries
- Battery Type: 3V Lithium Battery
- Battery Life: Up to 2+ Hours
- Product Dimensions (L x W x H): 25.9” x 9.0” x 10.6” -inches
PLBAS102LE
10” Dual Bass Subwoofer Box System
Rear Vented Design with Built-in Illuminating LED Lights
Technical Specs:
- Construction Materials: 15mm Particle Board + Multilayer Board
- Power Rating: 2×500 Watts Max Power
- Voice Coil: 2.0”
- Impedance: 4 Ohms
- Magnet: 2×40 Oz
- Sensitivity: 91 dB
- Frequency Response: 35-600 Hz
- Remote Control Battery Operated, Requires (1) x ‘CR2025’ Batteries
- Battery Type: 3V Lithium Battery
- Battery Life: Up to 2+ Hours
- Product Dimensions (L x W x H): 30.7” x 11.8” x 13.0” -inches
PLBAS122LE
12” Dual Bass Subwoofer Box System
Rear Vented Design with Built-in Illuminating LED Lights
Technical Specs:
- Construction Materials: 15mm Particle Board + Multilayer Board
- Power Rating: 2×600 Watts Max Power
- Voice Coil: 2.0”
- Impedance: 4 Ohms
- Magnet: 2×50 Oz
- Sensitivity: 91 dB
- Frequency Response: 30-300 Hz
- Remote Control Battery Operated, Requires (1) x ‘CR2025’ Batteries
- Battery Type: 3V Lithium Battery
- Battery Life: Up to 2+ Hours
- Product Dimensions (L x W x H): 33.8” x 12.6” x 14.9” -inches
Questions? Issues?
We are here to help!
Phone: (1) 718-535-1800
Email: support@pyleusa.com
WARNING:
This product contains Nickel carbonate which is known to the state of California to cause cancer birth defects and other reproductive harm. Do not ingest.
For more info go to: www.P65warnings.ca.gov
Documents / Resources
 |
PYLE PLBAS82LE Active Dual Bass Subwoofer Box System [pdf] User Guide PLBAS82LE, PLBAS102LE, PLBAS122LE, Active Dual Bass Subwoofer Box System, PLBAS82LE Active Dual Bass Subwoofer Box System, Subwoofer Box System, Box System |
