User Manual for Digtec Technology models including: DT-X7T, DT-X7T 3 In 1 Foldable Wireless Charger, 3 In 1 Foldable Wireless Charger, Foldable Wireless Charger, Wireless Charger, Charger
Shenzhen Digtec Technology Co., Ltd DT-X7T 2AVI4-DT-X7T 2AVI4DTX7T dt x7t
Charging Coil for Phone Special designed for Galaxy Z Flip series, which is compatible with all Qi enabled devices, as well as for earbuds(3W) and watch(3W). LED Indicator Charging Pad for Earphone Charging Spot for Watch Input Port Type-C Indicator light identification: How to identify Samsung Watch or Apple Watch versions? Apple Watch Version Icon Samsung Watch Version Icon A. Apple Watch Version: B. Samsung Watch Version: Only for S1-S9/SE/Ultra series etc. (3W) Only for Galaxy Watch 6/5/4/3 etc. (3W) Notice: Samsung watch charger does not support charging Apple watch Apple watch charger does not support charging Samsung watch For foldable phone Samsung version Not support vertical charging mode For other Qi enabled phones Phone FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.Adobe PDF library 15.00 Adobe Illustrator 25.0 (Windows)