Counter Inline Conversion Kit
Instruction Manual 

Under Counter Inline Conversion Kit
This kit is used specifically for converting a single-stage countertop unit to an under-counter unit that runs in line with the existing cold water line.

Contents

Your kit includes the following:
(a) bracket w/4 screws
(b) brass fittings (2)
(c) stainless steel 30” flex hose with 3/8” female ends

Installing Your Kit

1. Uninstall the countertop unit from the faucet.
2. Remove the base from the countertop unit.
3. Install bracket(a) in place of countertop base.
4. Remove spout and existing inlet fitting.
5. Install new lead-free brass fittings(b) using Teflon tape (about 2 wraps per fitting)
6. Turn off cold water supply under the sink.
7. Remove the existing line from shutoff valve.
8. Install flex hose(c)
9. Reconnect line (d) *Periodically check the installation for any leaks.

For technical support call
1(800)544-3533 or email
support@prooneusa.com

Documents / Resources

ProOne Under Counter Inline Conversion Kit [pdf] Instruction Manual Under Counter Inline Conversion, Counter Inline Conversion Kit, Counter Inline Conversion, Inline Conversion

References

• User Manual