PROJECTA PM4SWLED Low Profile 4 Inch LCD Colour Display
IMPORTANT SAFETY INFORMATION
Please read this manual thoroughly before use and store in a safe place for future reference.
WARNINGS
- Explosive gases. Prevent flames and sparks. Provide adequate ventilation during charging
- Before charging, read the instructions
- For indoor use ONLY. Do not expose to rain
- For charging lead acid and LiFePO4 batteries ONLY (of the size & voltage specified in the specifications table)
- Always charge the battery on the correct voltage setting. Never set the charger to a higher voltage than the battery specifications state
- Disconnect the 240V mains supply before making or breaking the connections to the battery
- The battery charger must be plugged into an earthed socket outlet
- Connection to supply mains is to be in accordance with national wiring rules
- Do not attempt to charge non-rechargeable batteries
- Never charge a frozen battery
- If AC cord is damaged, do not attempt to use. It must be replaced or repaired by a qualified technician
- Corrosive substances may escape from the battery during charging and damage delicate surfaces. Store and charge in a suitable area
- Where possible, ensure all vehicle accessories including lights, heaters, appliances etc. are turned off prior to charging
- This charger is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety
- Children being supervised not to play with the appliance
- If the recreational vehicle is to be put into storage without power, please turn off the BATTERY MASTER SWITCH. If the recreational vehicle is to be put into long term storage without power, disconnect ALL cabling from the battery
Product Instructions
Overview
The PM4SWLED monitor is a versatile and user-friendly device designed to work seamlessly with Projecta’s range of power management systems. It features an intuitive LED display that provides real-time information about the system’s status, allowing users to monitor the water tank levels and battery status at a glance. It also allows the user to control up to two pumps and the system’s power supply with the push of a button.
Features
- L.E.D lights for showing system states.
- Push button switches for controlling pumps, night mode and load.
Display
| No. | Name | Type | Description |
| 1 | Water Pump1 | DC Load Control | Load control, ON/OFF control |
| 2 | Water Pump2 | DC Load Control | Load control, ON/OFF control |
| 3 | Night Mode | Scene Mode | Charger fan will be turned off or decreased in speed |
| 4 | Load | DC Load Control | Load control, ON/OFF control |
| 5 | Fresh Water Tank | Sensor | Detect the level of fresh water tank |
| 6 | Tap Water Tank | Sensor | Detect the level of tap water tank |
| 7 | Waste Water Tank | Sensor | Detect the level of waste water tank |
| 8 | SOC | SOC | Detect the state of charge of the service battery |
| 9 | Service Battery | Voltage | Detect the voltage of the service battery |
| LED | COLOUR | STATUS | DESCRIPTION |
|
Mains |
GREEN |
ON | AC input OK |
| OFF | AC disconnected | ||
| Quick flashing | AC input abnormal | ||
|
PV |
GREEN |
ON | Starter charging the battery |
| Slow flashing (once every second) | The input of the Aux is normal but battery is charged by AC Mains | ||
| Quick flashing (twice every second) | Solar input abnormal | ||
| OFF | Solar disconnected | ||
|
FAULT |
RED |
ON | Short circuit |
| 1 flash | Service battery undervoltage | ||
| 2 flash | Service battery overvoltage | ||
| 3 flash | Over temperature (heat sink) | ||
| 4 flash | Bulk charge time-out | ||
| 5 flash | VSR abnormal | ||
| 8 flash | Over temperature (Unit) | ||
| 9 flash | Over temperature (PCB or Load circuit) |
Structure and Installation
Specification
| Model | PM4SWLED |
| Input | 12Vd.c |
| PHYSICAL SPECIFICATION | |
| Dimension | 150mm*90mm*24mm |
| Weight | 200g |
| Protection Category | IP20 |
| Approvals | |
| EMC | CISPR14 |
WARRANTY STATEMENT
Applicable only to products sold in Australia
Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic., telephone (03) 9730 6000, fax (03) 9730 6050, warrants that all products described in its current catalogue (save and except for all bulbs and lenses whether made of glass or some other substance) will under normal use and service be free of failures in material and workmanship for a period of five (5) year (unless this period has been extended as indicated elsewhere) from the date of the original purchase by the consumer as marked on the invoice. This warranty does not cover ordinary wear and tear, abuse, alteration of products or damage caused by the consumer.
To make a warranty claim the consumer must deliver the product at their cost to the original place of purchase or to any other place which may be nominated by either BWI or the retailer from where the product was bought in order that a warranty assessment may be performed. The consumer must also deliver the original invoice evidencing the date and place of purchase, together with an explanation in writing as to the nature of the claim.
In the event that the claim is determined to be for a minor failure of the product,t then BWI reserves the right to repair or replace it at its discretion. In the event that a major failure is determined, the consumer will be entitled to a replacement or a refund as well as compensation for any other reasonably foreseeable loss or damage. This warranty is in addition to any other rights or remedies that the consumer may have under State or Federal legislation.
IMPORTANT NOTE
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Distributed by
AUSTRALIA
Brown & Watson International Pty Ltd
Knoxfield, Victoria 3180
Telephone (03) 9730 6000
Facsimile (03) 9730 6050
National Toll Free 1800 113 443
NEW ZEALAND
Narva New Zealand Ltd
22–24 Olive Road
PO Box 12556 Penrose Auckland, New Zealand Telephone (09) 525 4575
IS611
Issue 1 1/7/24
Documents / Resources
 |
PROJECTA PM4SWLED Low Profile 4 Inch LCD Colour Display [pdf] Instruction Manual PM4SWLED, PM4SWLED Low Profile 4 Inch LCD Colour Display, Low Profile 4 Inch LCD Colour Display, 4 Inch LCD Colour Display, LCD Colour Display, Colour Display |