PRODEMAND 3RD ROW SEAT BACK PIVOT ACTUATOR MOTOR
REPAIR INSTRUCTIONS
Fig 1: 3rd Row Seat Back Pivot Actuator Motor – Back Cushion
| Callout | Component Name |
| Preliminary Procedures
1. Remove the 3rd row seat back cover and pad. Refer to 3rd Row Seat Back Cover and Pad Replacement (40%)3rd Row Seat Back Cover and Pad Replacement (60%) .
2. Remove the 3rd row seat back hinge finish cover. Refer to 3rd Row Seat Back Hinge Finish Cover Replacement (40% Inboard with AS8)3rd Row Seat Back Hinge Finish Cover Replacement (40% Outboard with AS8)3rd Row Seat Back Hinge Finish Cover Replacement (60% Inboard with AS8)3rd Row Seat Back Hinge Finish Cover Replacement (60% Outboard with AS8)3rd Row Seat Back Hinge Finish Cover Replacement (60% Inboard with ARN)3rd Row Seat Back Hinge Finish Cover Replacement (60% Outboard with ARN)3rd Row Seat Back Hinge Finish Cover Replacement |
|
| (40% Outboard with ARN)3rd Row Seat Back Hinge Finish Cover Replacement (40% Inboard with ARN) . | |
| 1 | 3rd Row Seat Back Pivot Actuator Motor Bolt
CAUTION: Refer to Fastener Caution . 28 N.m (21 lb ft) NOTE: The seat back frame is under spring tension. When the motor is removed, the seat frame will suddenly spring into the folded position. |
| 2 | 3rd Row Seat Back Pivot Actuator Motor Procedure
1. Disconnect the electrical connector.
2. Slide the motor off of the gear keyed bracket on the frame.
3. Transfer the mounting bracket, if necessary. |
Documents / Resources
 |
PRODEMAND 3RD ROW SEAT BACK PIVOT ACTUATOR MOTOR [pdf] Instructions 3RD ROW SEAT BACK PIVOT ACTUATOR MOTOR, ROW SEAT BACK PIVOT ACTUATOR MOTOR, PIVOT ACTUATOR MOTOR, ACTUATOR MOTOR |
