Sandmaster – COMPACT
Installing the Sand Flow Cube Upgrade Kit

SM Compact Sand Flow Cube Upgrade Kit

Replacing the T-Junction on the Sandmaster compact and with the Sand Flow Cube upgrade kit provides a more efficient flow of Air/Oxide ratio giving better sandblasting results.

1. Ensure the Pressure pot is depressurized.
2. Disconnect the Sandblasting Hose to the right of the T-Junction.
3. Disconnect the Airline just below the ball valve.
4. Disconnect the T-Junction from the Pressure Pot, ensure you have a container ready to capture the oxide in the pot.

Installation

1. Connect the Sand Flow Cube to the bottom of the pressure pot.
2. Connect the Black hose to the bottom of the ball Valve.
3. Connect the Sandblasting Hose to the Right side of the Sand Flow Cube.

Refill the Pressure pot with Oxide, Pressurize and you are ready to Sandblast.

Documents / Resources

ProBlast SM Compact Sand Flow Cube Upgrade Kit [pdf] User Manual SM Compact Sand Flow Cube Upgrade Kit, Compact Sand Flow Cube Upgrade Kit, Sand Flow Cube Upgrade Kit, Cube Upgrade Kit, Upgrade Kit

References

• User Manual