Operating instructions
Windbreak inflatable

367808 Inflatable Windshield

SAFETY INSTRUCTIONS

• Read the instruction manual carefully before use and keep it for future reference.
• Make a test setup first before the product is used in practice.
• Check the windbreak for signs of damage before use.
• Ensure that the hose connection is not impeded (by a kink).
• The windbreak is intended for use in light to moderate weather. In case of strong wind, we recommend breaking off the windshield (setup) or not setting it up.
• Long-term use in strong sunlight is not recommended; if possible, set up the windbreak (in part) in a shady environment.
• UV damage is not covered by the warranty; damage caused by sunlight is at your own risk.

USAGE

1. Locate the inflation valve / inflation valves and ensure that they are fully tightened before air is pumped into the windshield (fig. 1, part A and B). The cap (fig. 1, part C) must be loosened for inflation. To deflate the windshield, the middle ring must be loosened (fig. 1, part B).
2. Inflate the windbreak, with the supplied pump, at the inflation valve(s). For art.nr. 367804 a pump is not included. With item no. 367806 and 367808 the pump is protected against overload by means of a pressure relief valve. If this pump is not used, the recommended inflation pressure is 7 psi (0.48 bar)
3. Guide the windbreak so that it is in the correct position (fig. 2).
4. Secure the windbreak with pegs and guy lines and start with the corners (fig. 3).
5. Clamp the external guy lines (fig. 4) to the windbreak and ensure the position of the windbreak.

Take down the installation

1. Drain the windbreak by turning the drain valves (fig. 5). To deflate the windshield, the middle ring must be loosened (fig. 1, part B).
2. Remove all pegs and loosen all guy lines.
3. Fold and roll towards the opened valves. This leaves the remaining air out.
4. Roll up the windbreak, place in the carrying bag and zip it closed.

MAINTENANCE

• Fully vent the windbreak and make sure it is completely dry before it is packed.
• Store in a well-ventiated dry place.
• Do not wrap the windshield wet / damp to prevent mold. Clean with water and a soft brush. Do not use: cleaning agents and do not scrub hard.
• The windbreak requires no maintenance but must be protected against damage during storage.
• Damage as a result of improper use, wind damage o neglect is not covered by the warranty.
• Have any damage repaired at the first opportunity.

PAT Europe B.V.
Haarspit 1
1724 BG Oudkarspel
The Netherlands

Documents / Resources

Pro Plus 367808 Inflatable Windshield [pdf] Instruction Manual 367804, 367806, 367808, 367808 Inflatable Windshield, 367808, Inflatable Windshield, Windshield

References

• User Manual