Contents
hide
PREVUE HENDRYX 58500 Ferret Stack Add-On Unit Instruction Manual
CUSTOMER SUPPORT
Please contact Prevue Pet Products:
PHONE 1 312-243-3624
ONLINE www.prevuepet.com
EMAIL customerservice@prevuepet.com
ADD-ON SET: WHAT IT IS / WHERE TO ADD IT
1 PIECES
At the lower-corner bracket:
- REMOVE the top-hole screws
- LOOSEN the bottom-hole screws
You may want to take out the platform & ramp.
- REMOVE the entire top floor unit.
- Reserve the four screws for re-attachment.
- Stand the ADD-ON left side and front panels in position and hand-tighten hex screws in the bottom hole of the top bracket and the open hole at the base.
- Continue adding and attaching the back and right side panels with handtightened hex screws
- Place the ADD-ON mid-level floor panel in position and attach with a hand-tightened hex screw, one at each end.
- REPLACE the top unit onto the ADD-ON floor addition.
- Attach the top floor unit with the four screws reserved at the beginning.
- Tighten ALL screws with the hex key until snug.
- Replace platforms and ramps.
Assembly completed
Read More About This Manual & Download PDF:
Documents / Resources
 |
PREVUE HENDRYX 58500 Ferret Stack Add-On Unit [pdf] Instruction Manual 58500 Ferret Stack Add-On Unit, 58500, Ferret Stack Add-On Unit, Stack Add-On Unit, Add-On Unit, Ferret Stack, Stack |
