PREVIDIA C-COM Serial and IP Module Interface Instruction Manual

Ensure that the power supply voltage is within the range of 19-30V.
Connect the module to the appropriate RS485 and RS232 connections as per the provided specifications.

If using the PREVIDIA-C-DIAL mounting option, follow the mounting instructions provided for proper installation.
Insert an SD card with the required capacity into the module.

Ensure that the operating temperature is within the specified range for optimal performance.
Refer to the user manual for any additional instructions or guidelines.

Please note that this product does not support 220V power supply or battery usage. For further information, refer to the user manual available for download from the official website of INIM Electronics S.r.l.

Technical specifications

Power supply voltage

Current draw
Operating temperature

Capacity of SD-card

Mounting

Mounting with PREVIDIA-C-DIAL

Wiring the board

Download

Directive 2014/53/EU
Hereby, INIM Electronics S.r.l. declares that these Previdia Compact control panels are in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. This product may be used in all EU Countries.

Documents for the users
Declarations of Performance, Declarations of Conformity and Certificates concerning to INIM Electronics S.r.l. products may be downloaded free of charge from the web address www.inim.biz, getting access to Extended Access and then selecting “Certifications” or requested to the e-mail address info@inim.biz or requested by ordinary mail to the address shown in this manual. Manuals may be downloaded free of charge from the web address www.inim.biz, getting access to Extended Access and then selecting “Manuals”

DISPOSAL

WEEE

Informative notice regarding the disposal of electrical and electronic equipment (applicable in countries with differentiated waste collection systems) The crossed-out bin symbol on the equipment or on its packaging indicates that the product must be disposed of correctly at the end of its working life and should never be disposed of together with general household waste. The user, therefore, must take the equipment that has reached the end of its working life to the appropriate civic amenities site designated to the differentiated collection of electrical and electronic waste. As an alternative to the autonomous-management of electrical and electronic waste, you can hand over the equipment you wish to dispose of to a dealer when purchasing new equipment of the same type. You are also entitled to convey for disposal small electronic-waste products with dimensions of less than 25cm to the premises of electronic retail outlets with sales areas of at least 400m2, free of charge and without any obligation to buy. Appropriate differentiated waste collection for the subsequent recycling of the discarded equipment, its treatment, and its environmentally compatible disposal helps to avoid possible negative effects on the environment and on health and favors the re-use and/or recycling of the materials it is made of.

Copyright
The information contained in this document is the sole property of INIM Electronics s.r.l. No part may be copied without written authorization from INIM Electronics s.r.l. All rights reserved.

ISO 9001 Quality Management certified by BSI with certificate number FM530352

Inim Electronics S.r.l.
Centobuchi, via Dei Lavoratori 10
63076 Monteprandone (AP) Italy
Tel. +39 0735 705007
Fax +39 0735 70491
info@inim.biz _ www.inim.biz

Documents / Resources

PREVIDIA C-COM Serial and IP Module Interface [pdf] Instruction Manual
C-COM Serial and IP Module Interface, C-COM, Serial and IP Module Interface, Module Interface

References

User Manual

PREVIDIA C-COM Serial and IP Module Interface

Product Information

Product Usage Instructions