PowerFlex Holster Doc Hub User Guide
Installing Holsters
Materials needed:
- Holster (provided by PowerFlex)
- Power drill
- Drill bits (Phillips, hex, torx, flathead)
- Assorted screws for various surface types (most common are metal, brick, concrete, and drywall)
Powerflex supplies 3 holster types – standard, J-hook, and Z. Examples of each are shown below.
PowerFlex Support Line: 833-479-7359
If the existing holster is broken but the holes are intact, simply remove the broken holster and replace with a new one.
If new holes need to be drilled, drill 4 holes then mount the holster with the appropriate screws.
Documents / Resources
 |
PowerFlex Holster Doc Hub [pdf] User Guide Holster Doc Hub, Holster, Doc Hub, Hub |