POWERBLOCK Pro Rack Stand Installation Guide

POWERBLOCK Pro Rack Stand

PRO RACK STAND ASSEMBLY STEP 1

TOOLS NEEDED

TWO 17mm WRENCHES.

1. ATTACH THE BOTTOM SHELF (ITEM 3) TO ONE STAND LEG (ITEM 1) WITH SUPPLIED HARDWARE. DO NOT TIGHTEN HARDWARE.
2. ATTACH OTHER STAND LEG (ITEM 1) TO THE BOTTOM SHELF (ITEM 3) WITH SUPPLIED HARDWARE. DO NOT TIGHTEN HARDWARE.
3. ATTACH STAND TOP (ITEM 2) TO ONE STAND LEG (ITEM 1) WITH SUPPLIED HARDWARE. DO NOT TIGHTEN HARDWARE.
4. ATTACH OTHER STAND LEG (ITEM 1) TO STAND TOP (ITEM 2) WITH SUPPLIED HARDWARE. DO NOT TIGHTEN HARDWARE.
5. TIGHTENING THE HARDWARE WHILE ENSURING ALL FOUR FEET ARE IN FULL CONTACT WITH THE GROUND. INSTALL THE INCLUDED LEVELING MOUNTS IF NECESSARY(SEE NEXT PAGE).

FOR USE ON FIRM AND FLAT SURFACE ONLY

PRO RACK STAND ASSEMBLY STEP 2

1. OPTIONAL: ATTACH LEVELING MOUNTS (ITEM 1) TO BOTTOM FOOT PLATES AND ADJUST THE HEIGHT OF THE LEVELING MOUNTS BY LOOSENING OR TIGHTENING OF THE THREADS. THEN TIGHTEN THE JAM NUTS.
   FOR USE ON FIRM AND FLAT SURFACE ONLY

IMPORTANT SAFETY INSTRUCTIONS

1. Read and fully understand all instructions contained in this manual prior to using the product. Be alerted to the possibility of injury. Do not be careless.
2. Inspect the stand prior to each use. Do not use a stand with worn, damaged, or loose parts, fasteners or hardware.
3. MAX LOAD: 750 lb.
4. Before beginning your workout, make certain that your surroundings are free from potential interference.

• WARNING: Injury may occur if stand top tray and lower storage shelf are not emptied prior to moving the stand. Stand should be moved in a slow and controlled manner.
• WARNING: Never allow children to use or play near this equipment. Anyone under the age of 18 must always have parental supervision and instruction on the use of these products.
• WARNING: Injury may occur if stand is not assembled per the instruction manual. If you have any questions regarding the assembly, please contact customers service at 1-800-997-3999 .
• WARNING: Use the stand on a FLAT AND FIRM SURFACE ONLY. Damage to the products and potential injury may occur.