POWER-LITE logoINSTRUCTION MANUAL
Push Button Dimmer
DS-PPOWER LITE DS P Push Button Dimmer

DS-P Push Button Dimmer

POWER LITE DS P Push Button Dimmer - SymbolPOWER LITE DS P Push Button Dimmer - size

Technical Data

Operating Voltage 220-240 V ~
Frequency 50 Hz
Maximum Load 350 W
Minimum Load 10 W
Dimming Mode Trailing Edge
Control Method Two way
POWER LITE DS P Push Button Dimmer - icon 1 Dimmable LED lamps  10-150W
POWER LITE DS P Push Button Dimmer - icon 2 LV Halogen lighting with electronic transformers 10-350VA
POWER LITE DS P Push Button Dimmer - icon 3 Incandescent lighting, MV Halogen lamps 10-350VA

Function

a) Minimum Brightness If an LED or CFL lamp becomes unstable at low dimming levels , it can flicker or pulse on/off. The dimmer’s minimum brightness can be set to a level above the point at which a lamp flickers or pulses.

  1. Remove the top tap.
  2. Hold down programming button until LED slow flashing.
  3. Hold down the button to the setting level.
  4. Double press the button to exit programming mode.

b) Maximum Brightness The maximum brightness level provided by the dimmer can be set to suit customer requirements.

  1. Remove the top tap.
  2. Hold down the programming button when LED start slow flashing then press the button again the LED will start quick flashing.
  3. Hold down the button to the setting level.
  4. Double press the button to exit programming mode.

c) LED Indicator The blue led indicator will be on when the dimmer is on.
d) Memory Dimmer The dimmer has the option to turn on at the brightness level set when the lights were turned off/on at the last setting brightness.
e) Protection: Overload, short-circuit, over current, over temperature protection.

Installation

The Installation must be carried out by an electrician!
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
! Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician.POWER LITE DS P Push Button Dimmer - Wiring DiagramNOTE:

  • The LED dimmer series are designed for One-Way or Two-Way operation as above diagrams.
  • More than one dimmers cannot be connected in parallel or series to control the same load from two different locations.
  • Dimmer Mechanism wiring is NOT polarity sensitive.

POWER-LITE logo

Documents / Resources

POWER-LITE DS-P Push Button Dimmer [pdf] Instruction Manual
DS-P Push Button Dimmer, DS-P, Push Button Dimmer, Button Dimmer, Dimmer

References

Leave a comment

Your email address will not be published. Required fields are marked *