POINT Mobile RF851 High-Performance UHF RFID Trigger LOGO

POINT Mobile RF851 High-Performance UHF RFID Trigger

POINT Mobile RF851 High-Performance UHF RFID Trigger PRO

Package Contents and Accessories

POINT Mobile RF851 High-Performance UHF RFID Trigger 1

Optional Accessories
Single Slot Cradle and Single Slot Ethernet Cradle

POINT Mobile RF851 High-Performance UHF RFID Trigger 2

Device Layout

POINT Mobile RF851 High-Performance UHF RFID Trigger 3

  1. UHF Antenna
  2. LED Indicator
  3. Trigger-Mode key
  4. Connect-Mode Key
  5. Trigger
  6. USB Type-C Connector
  7. Battery Release Button
  8. Power key

Charging the RF851

POINT Mobile RF851 High-Performance UHF RFID Trigger 4

The RF851 and PM85 are charged individually. Charge the RF851 by inserting the USB Type-C cable to the connector. The RF851 is fully charged when the charging LED is solid green (see next page for LED indicator)

Caution

  1. Always use an original power supply from Point Mobile. Other chargers and cables may damage the RF851.
  2. Make sure the connector, charger, cable is not wet.
  3. The device warranty does not cover any damage caused by the usage of non-original power supplies

Specifications

Item Specifications
Frequency UHF 900MHz
Protocol ISO 18000-63(18000-6C) / EPC global Oass 1 Gen 2
Output Max. 30 dBm(lWatt)
USB USB Type C / USB to Serial Communication
Bluetooth Bluetooth v4.0(Classic + Low Energy)/ SSP Profile
LED LED(Charging /State/ Connect-Mode/ Trigger-Mode)
Button Power, Trigger Mode, Connection Mode
Buzzer Max, Min, Mute
Configurations RAD only or RAD with 20 scanner(Optional)
Size 81.3(W) x 153.B(L) x 142.2(H) mm
Battery 3,250 mA, 3.635 V LHon (Replaceable)
Battery Charge Time AC : About 4H
Drop 1.SM
Adaptor SV / 2A
Weight 364g

LED Indicator

POINT Mobile RF851 High-Performance UHF RFID Trigger 5

 

1. Charging LED

Solid Red Solid Green Battery is charg ng Battery is charged
 

2. State LED

Solid Red Blinking Red Solid Green Power is On Power is low BT is connected
 

3 , Connect-Mode LED

Turned off Solid Red SPP connected UART connected
 

4. Trigger-Mode LED

 

Turned off Solid Red

 

UHF RFID ready Barcode scan ready

Battery Replacement

POINT Mobile RF851 High-Performance UHF RFID Trigger 6

  1. Press PUSH button on the back of the handle to replace the battery
  2. When the battery cover is open, the battery can be easily taken out and replaced with a new one.

Documents / Resources

POINT Mobile RF851 High-Performance UHF RFID Trigger [pdf] User Guide
RF851, V2X-RF851, V2XRF851, RF851 High-Performance UHF RFID Trigger, High-Performance UHF RFID Trigger

References

Leave a comment

Your email address will not be published. Required fields are marked *