Instrukcja obsługi automatycznego robota czyszczącego basen AIPER Orca 800 Mate

1. Wprowadzenie

The AIPER Orca 800 Mate is an automatic robotic pool cleaner designed to simplify pool maintenance. This manual provides essential information for the safe and efficient operation, setup, and maintenance of your device.

Figure 1: AIPER Orca 800 Mate Robotic Pool Cleaner

2. Informacje dotyczące bezpieczeństwa

Always follow basic safety precautions when operating electrical appliances. Read all instructions before use.

• Ensure the power source is appropriate for the device's voltage (127 woltów).
• Nie używaj odkurzacza, jeśli przewód zasilający jest uszkodzony.
• Keep children and pets away from the pool area during operation.
• Always unplug the cleaner from the power source before performing any maintenance or cleaning tasks.
• Nie wchodź do basenu, gdy robot kuchenny pracuje.

3. Konfiguracja

The AIPER Orca 800 Mate is designed for quick and easy setup. No booster pump, extra hoses, or complex installation is required.

1. Remove the pool cleaner from its packaging.
2. Clean any removable parts with warm, soapy water if necessary.
3. Connect the floating cable to the cleaner and the power control box.
4. Plug the power control box into a grounded power source.
5. Carefully place the pool cleaner into the pool. Allow it to sink to the bottom and fill with water.

Figure 2: Lowering the cleaner into the pool

4. Instrukcja obsługi

The Orca 800 Mate features powerful suction and intelligent navigation for thorough cleaning.

4.1 Rozpoczęcie pracy

1. Once the cleaner has sunk to the bottom and is filled with water (approximately 1-2 minutes), press the ON/OFF button on the power control box.
2. The cleaner will begin its cleaning cycle.
3. Ensure the floating cable is not tangled and has enough slack for the cleaner to move freely.

4.2 tryby czyszczenia

The cleaner is equipped with a unique swing plate that automatically reverses its cleaning direction when it touches the pool wall, preventing it from getting stuck. It can traverse the pool bottom and climb inclines up to 30 degrees.

• Standardowe sprzątanie: The cleaner will operate for 2-3 hours, cleaning the pool bottom, walls, and waterline.
• Efektywność energetyczna: Operating at an average cost of 5 cents per hour, this robotic cleaner is an energy-efficient alternative to traditional pool pumps and hoses.

Figure 3: Pool before and after cleaning

4.3 Kontrola aplikacji (jeśli dotyczy)

Some models may offer app control for advanced features and manual steering. Refer to the app's instructions for specific functionalities.

Video 1: Aiper Orca 800 Pool Vacuum Cleaner in action, demonstrating its cleaning capabilities.

5. Konserwacja

Regularna konserwacja zapewnia optymalną wydajność i długą żywotność odkurzacza basenowego.

5.1 Czyszczenie filtra

The Orca 800 Mate features superior filtering capabilities, trapping and locking in dirt and debris like leaves and sand. The large filter basket (1 Gallon capacity) is easy to access and clean.

1. When the cleaning cycle is complete, retrieve the cleaner from the pool.
2. Allow excess water to drain from the unit.
3. Aby uzyskać dostęp do koszyka filtra, należy otworzyć górną pokrywę odkurzacza.
4. Wyjmij koszyk filtra i opróżnij go ze wszystkich nagromadzonych zanieczyszczeń.
5. Dokładnie wypłucz kosz filtra przy użyciu węża, aby usunąć drobne cząsteczki.
6. Reinsert the clean filter basket and close the cover securely.

Figure 4: Easy filter cleaning

5.2 Przechowywanie

Przechowuj środek czyszczący w chłodnym i suchym miejscu, z dala od bezpośredniego światła słonecznego, gdy nie jest używany.

6. Rozwiązywanie Problemów

If you encounter issues with your AIPER Orca 800 Mate, please refer to the following common troubleshooting tips:

• Sprzątaczka się nie rusza: Ensure the power control box is properly plugged in and the ON/OFF button is pressed. Check for any obstructions in the cleaner's wheels or brushes.
• Słaba skuteczność czyszczenia: Clean the filter basket thoroughly. Ensure the pool water chemistry is balanced. Check for any large debris blocking the suction inlets.
• Cleaner getting stuck: The swing plate mechanism should prevent this. If it occurs, manually reposition the cleaner. Ensure the pool bottom is free of large obstacles.
• Plątanie się kabli: Ensure the floating cable is properly deployed and not excessively long for the pool size. Allow the cleaner to pull only the necessary length of cable.

Video 2: Customer use video demonstrating the cleaner's operation and retrieval.

7. Specyfikacje

8. Gwarancja i wsparcie

AIPER is committed to providing hassle-free, smart, and simple pool cleaning solutions.

• The AIPER Orca 800 Mate comes with a 2-year warranty.
• For worry-free customer service and support, please contact AIPER directly.