PITSCO EDUCATION 42432 FLO Fog Generator User Guide

Fill a syringe with 0.5 ml of the Steam-Smoke Distillate fluid.
Empty the fluid into the black-and-gold hole at the top of the fog generator. Do not touch the heating element in the middle of the hole.

Place the nozzle on the fog generator.
Plug the power supply into the fog generator and press the On button to produce fog.

FAQ
Q: What should I do if the fog volume is diminished?
A: Ensure that you are using the correct Steam-Smoke Distillate fluid and that you have not overfilled the generator.

TROUBLESHOOTING

THE FOG GENERATOR
If the fog generator does not seem to be working properly, please check the following:

Fluid level – if there is too much fluid added to the generator, it will not produce a large volume of fog. Make sure all fluid is gone before adding 0.5 ml of fog fluid.
Be certain you are using the correct type of fluid for this generator. Fluid must say “Steam-Smoke Distillate” on the label. Fluid for earlier versions of the Pitsco Fog Generator will not work.

CAUTIONARY AND WARNING STATEMENTS

This unit is designed and intended for educational purposes only.

Use only under the direct supervision of an adult who has read and understood the instructions provided in this user guide.
Read warnin gs on packaging and in manual carefully.

Safety glasses are required.
Use only fog fluid labeled “Steam-Smoke Distillate” with the FLO Fog Generator.

Do not overfill the fog generator; fog output will diminish.

HAZARDOUS CHEMICAL WARNING
The included 50 ml bottle of fog fl uid contains hazardous chemicals.

DO NOT SWALLOW – Fluid might cause lung damage if swallowed.
Eye contact – Flush eyes with large amounts of water until irritation subsides. If irritation persists, get medical attention.
Skin contact – Flush with large amounts of water; use soap if available. Repeated exposure might cause skin dryness or cracking.

Inhalation – Use in a well-ventilated area when generating smoke from fluid. If smoke causes irritation, remove individual from area.
Ingestion – If swallowed, do not induce vomiting. Keep at rest. Get prompt medical attention.

MATERIALS INCLUDED

1 FLO Fog Generator

1 bottle of fog fluid (50 ml)
2 syringes

1 power supply (12 V)

USING THE FOG GENERATOR

Empty the fog generator of any fluid from previous sessions before filling the generator with fluid. If too muchfluid is added, fog volume will be diminished. Use only fog fluid that says “Steam-Smoke Distillate” on the label.
Fill a syringe with 0.5 ml of the fluid (Figure 1).
Empty the fluid into the black-and-gold hole at the top of the fog generator (Figure 2).Note: Do not press on the heating element in the middle of the hole. You could damage the heating element.
Place the nozzle on the fog generator (Figure 3).
Plug the power supply into the fog generator and press the On button to produce fog.