PIONEER-logo

PIONEER TS-D10D4 Component Subwoofer

PIONEER-TS-D10D4-Component-Subwoofer-product

TS-D12D4 TS-D10D4 2000wMt-x./NOM.600w
TS-D12D2 TS-D10D2 15QQWMtK./NOM.5QQw

CAR-USE COMPONENT SUBWOOFER

Be sure to read this instruction manual before installing this speaker.

WARNING
The sealed enclosure series subwoofers are capable of reproducing music at extremely loud levels. Caution should be exercised lo prevent permanent hearing loss. Additionally, driving with the system at high volume levels could impair your ability to hear emergency vehicles.

CAUTION

  • To prevent damage to your speakers please observe the following caution.
  • At high volume levels if the music sounds distorted or additional sounds are perceived lower the volume.
  • PIONEER recommends that this speaker be used in conjunction with amplifiers whose continuous (RMS) output is lower than the nominal input power of this speaker.
  • Since this speaker is continuously used being turned on full blast, temperature of the magnetic circuit rises, avoid touching it directly by hand and placing something near ii. If ii is heated, it may cause a burn, deformation of or damage to peripheral things.
  • If this product is used in free-air conditions (without an enclosure), insufficient damping causes the sound without accuracy and reduces the power handling capability to 1/4 of its usual levels. It may resuit in permanent damage to the product.

Information Note for Customers in Russia and CIS countries.

FEATURES

  1. High Dynamic Range delivers superior bass response and high linearity with wide dynamics and extremely low distortion.
  2. Aramid fiber interlaced IMPP ™ cone reproduces extraordinarily accurate and detailed bass.
  3. Extended voice coil combined with a rubber surround increases linear stability even during high excursion and high output.
  4. Heavy gauge steel woofer bask.et provides high strength supporting an oversized magnetic motor structure.
  5. Powerful motor assembly optimized using finite element analysis reproduces “Deep & Accurate” bass sound.
  6. Vented and projected pole yoke design provides more efficient heat dissipation and superior linearity during high excursion.

    PIONEER-TS-D10D4-Component-Subwoofer-fig-1

DVC

(DUAL VOICE COIL) CONNECTION

connection

  • 4 Q /2 Q Bridged mono (Parallel)
  • 2 Q/1 Q Stereo
  • 2 0. /1 Q Bridged mono

    PIONEER-TS-D10D4-Component-Subwoofer-fig-2

Speaker wiring

  • 8 Q/4Q Wiring
  • 2 0. /1 Q Wiring
  • 2Q/1 Q Wiring

    PIONEER-TS-D10D4-Component-Subwoofer-fig-3

  • Advantage
  • Good for higher sensitivity
  • Good for higher sensitivity
  • Good for channel separation
  • Good for higher sensitivity

Notice: Verify that yoLr amplifier can operate in 2 0 / 1 Q mono configuration.

CAUTION: Never connect only one voice coil of this Dual Voice Coil (DVC) speaker. Both voice coils must be connected to the amplifier for correct operation.

SPECIFICATIONS

C

 

Size

 

Nominal power

 

Max.music power

 

Nominal impedance

 

Sensitivity

 

Frequency response Magnetweight

 

Displacement.leHMe

 

Revc

 

(Q)

Leve (mH) Fs (Hz) Qms Qes Qts Vas

 

(lltars) (cu.ft)

Rms (N.S/m) Mms (g) Cms (rrvN) Diam

 

(mm)

(inch)

BL

 

(T.m)

Xmax

 

(mm)

(rich)

 

TS-D12D4

 

30cm (12″)

soow  

2000W

 

4 Q DVC

 

78 dB (1 W / 1 m)

20 Hz To 4.7 kHz

(-20 dB)

2 100 g (74 oz) 1.33 liters (0.047 cu.fl)  

Dual 3.3

 

Dual 1.7

 

Dual 3.6

 

Dual 1.7

 

4.52(8Q)

1.14(2Q)

 

34

 

9.75

 

0.74

 

0.69

 

47.9

1.69

 

3.92

 

183

 

1.3×10-4

 

256

10.1

 

19.2(8Q)

9.5(2Q)

 

13.0

0.51

TS-Dt2D2 30cm (12″) 600W 2000W 2 QDVC 76dB(1 W/1 m) 20 Hz To 4.7 kHz

(-20 dB)

2 100 g (74 oz) 1.33 llters (0.047 cu.ft) 2.80{4Q)

0.72(1Q)

33 9.71 0.69 0.64 462

1.63

4.13 193 1.2×10-4 256

10.1

14.6(4Q)

7.3(1Q)

13.0

0.51

TS-D10D4 25cm (10″) 500W 1500W 4 QDVC 76 dB (1 W / 1 m) 20 Hz To 6.6 kHz

(-20 dB)

1 600 g (56 oz) 0.96 llters (0.034 cu.tt) 4.31(8Q)

1.08(2Q)

41 8.41 0.85 0.77 22.3

0.79

3.69 124 1.4Xt0-4 209

a2

16.1(8Q)

8.0(2Q)

10.8

0.42

TS-01002 25cm (10″) 500W 1500W 2 QDVC 74dB(1 W/1 m) 20 Hz To 6.6 kHz

(-20 dB)

1 600 g (56 oz) 0.96 liters (0.034 cu.ft) 2.59(4Q)

0.66(1Q)

40 8.74 0.76 0.70 20.9

0.74

3.76 131 1.2x1o-4 209

8.2

12.7(4Q)

6.4(1Q)

9.8

0.38

RECOMMENDED

TS-D12D4 / TS-D12D2

PIONEER-TS-D10D4-Component-Subwoofer-fig-4

TS-D10D4 / TS-D10D2

PIONEER-TS-D10D4-Component-Subwoofer-fig-5

CHARACTERISTIC

PIONEER-TS-D10D4-Component-Subwoofer-fig-6

TEMPLATE

PIONEER-TS-D10D4-Component-Subwoofer-fig-7

© PIONEER CORPORATION 2017 28-8, Honkomagome 2-chome, Bunkyo-ku, Tokyo 113-0021, JAPAN

Documents / Resources

PIONEER TS-D10D4 Component Subwoofer [pdf] Instruction Manual
TS-D10D4 Component Subwoofer, TS-D10D4, Component Subwoofer, Subwoofer

References

Leave a comment

Your email address will not be published. Required fields are marked *