PHILIPS GPPR IGNSD Electronic Digital Control Ignitor For Hid Lamp Circuits
Electronic digital control ignitor for HID lamp circuits
- HID ignitors for series systems
Benefits
- Easy installation and wiring
- Can operate with both semi-parallel and series ballasts
- Digital ignitors ensure maximum reliability
Features
- Ignitors equipped with screw terminal blocks as standard
- Series ignitor will only work in series circuits
Application
- Outdoor lighting (most popular application: road and tunnel lighting)
Specifications
- Product Name: GPPR IGNSD
- Ignition Type: Digital ignitors
- Control Type: Electronic digital control ignitor for HID lamp circuits
- Dimensions:
- A1: 96 mm
- A2: 63.4 mm
- B1: 45 mm
- C1: 34 mm
- Product Family Leaflet: 2024, August 29
Versions
GPPR IGNSD
Product family least, 2024, August 29
Dimensional drawing
Installation
- Ensure the power source is switched off before installation.
- Refer to the dimensional drawing provided to determine the correct placement of the ignitor.
- Connect the ignitor following the circuit diagram for the HID lamp circuits.
- Secure the ignitor in place using appropriate fixtures.
Operation
- After installation, switch on the power source to activate the ignitor.
- Monitor the ignitor for proper functioning and ignition of the HID lamp.
- If there are any issues, refer to the troubleshooting section of the user manual.
Maintenance
- Regularly inspect the ignitor for any signs of damage or wear.
- Keep the ignitor clean and free from dust or debris that may affect its performance.
- Replace the ignitor if it shows signs of malfunction or failure.
FAQs
Q: Can I use this ignitor with LED lamps?
A: No, this ignitor is specifically designed for HID lamp circuits and may not be compatible with LED lamps.
Q: How do I know if the ignitor is working correctly?
A: You can check if the HID lamp ignites properly after switching on the power. If the lamp fails to ignite, there may be an issue with the ignitor.
Q: Is professional installation required for this product?
A: It is recommended to have the ignitor installed by a qualified electrician to ensure proper connection and safety.
2024 Signify Holding All rights reserved. Signify does not give any representation or warranty as to the accuracy or completeness of the information included herein and shall not be liable for any action in reliance thereon. The information presented in this document is not intended as any commercial order and does not form part of any quotation or contract unless otherwise agreed by Signify. All trademarks are owned by Signify Holding or their respective owners.
www.lighting.philips.com
2024, August 29 – data subject to change.
Documents / Resources
 |
PHILIPS GPPR IGNSD Electronic Digital Control Ignitor For Hid Lamp Circuits [pdf] Owner's Manual GPPR IGNSD, SU 42-S, GPPR IGNSD Electronic Digital Control Ignitor For Hid Lamp Circuits, GPPR IGNSD, Electronic Digital Control Ignitor For Hid Lamp Circuits, Control Ignitor For Hid Lamp Circuits, Ignitor For Hid Lamp Circuits, Hid Lamp Circuits, Lamp Circuits |