IN240600085V01_GL
D06-241V00 D06-241V01 D06-241V02
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
Adjustable width different extension fits openings width:
Product & Parts
a Main Gate x1
b Tension Bolt «4
c Wall cup 4
d suck Pad 4
e 9 screw x+1
f Dry Wall Anchor x4+1
g 7cm extension
h 14cm extension
i Reinforcement slot2
The picture is only for reference, please make the object as the standard.
WARNING: This package contains small parts and sharp points in an unassembled state. Keep out of reach of children. Adult assembly required.
WARNING:
To help your installation,Do not cut off the belt before installation is completed! The door gap is NOT a defect! It will be shortened to 0.2cm after installation.
The door gap is NOT a defect! after installation, it will be shortened to 0.2cm
DO NOT CUT THE BELT before the installation is completed.
Notice: screw in Mounting Cups when using gate on stairs
Bottom of stairs
If the gate is used at the bottom of the stairs to prevent the child from climbing up the stairs, it must be placed on the lowest stair.
Top of stairs
If the gate is used at the top of the stairs to prevent the child from falling down the stairs, it must be placed on any stair below the level of the top stair.
STEP1. Pre-assemble the gate, and locate four points for hole drilling. Hold the wall cup in position and mark the center with a pencil.
PLEASE NOTE: The gate should be resting on the floor. DO NOT allow a gap of more than 0.5cm between the gate and the floor.
STEP2. Stick pad when using pressure mounted installatioRemove two side of the sticky pad, stick 4 pads to 4 wall cups. Then wall cups cover the bolts.
TIP: If you do not have to worry about damaging the walls, skip this step.
STEP3. Drill hole for the 4 marked positions, then put dry wall anchor(g)and use screw(f)and the wall cup (d)
STEP4.
Tighten the top of the tension knobs by turning them clockwise at the same time
Note: Make sure the bottom of the gate frame remains completely flat on the floor.
Next, tighten the bottom of the tension knobs at the top on the same time by turning them clockwise.
STEP5.
Cut off the belt and test the gate:
- Push the gate to check stability.
- Open and close the walk through gate
Pull the button to the right, then lift the gate panel UP to open.
TROUBLE SHOTING
WARNING
- To prevent serious injury or death, securely install gate or enclosure and use according to manufacturer’s instructions.
- Use only with the locking mechanism securely engaged Stop using gate if any parts are missing or become damaged.
- ALWAYS install and use gates as directed using all required parts.
- Periodically check all fasteners to be sure they are tight and secure.
- Adult Assembly Required.
- The surfaces that the gate is to fixed to must be suitable for the purpose and must be structurally sound.
- Indoor use only , is not to be exposed to outdoor elements.
- Install this gate away from heaters and other sources of heat.
If you have any questions, please contact our customer care center, Our contact details are below:
001-877-644-9366
customerservice@aosom.com
Imported by Aosom LLC
27150 SW Kinsman Rd Wilsonville, OR 97070 USA
MADE IN CHINA
If you have any questions, please contact our customer care center, Our contact details are below:
0044-800-240-4004
enquiries@mhstar.co.uk
IMPORTER ADDRESS:
MH STAR UK LTD
Unit 27, Perivale Park,
Horsenden lane South
Perivale, U86 7RH
MADE IN CHINA
Documents / Resources
 |
PawHut D06 Pet Gate [pdf] Installation Guide D06 Pet Gate, D06, Pet Gate, Gate |
