UTV Stereo Powersports RGB LED Controller Kit
Wiring Diagram
Instructions
Step 1: Disconnect battery.
Step 2: Place RGB controller near the amplifier.
Step 3: Route RGB wire from the speakers to the RGB controller and amplifier. If you do not have an amplifier, route wires to source unit. (Reference Wire Diagram)
Step 4: Mount “Speaker Lights” switch, route Red and Black wires (two wires side) from harness and connect it to the RGB controller with the EZ 2-pin connector. (Reference Wire Diagram)
Step 5: Route bus bar wires (Yellow, Black, Red) from harness (three wire side) to the factory bus bar. (Reference Wire Diagram)
Step 6: Strip off 6 inches of the black outer jacket of each set RGB wire.
Step 7: Strip each individual 22 AWG wire, exposing the metal underneath. Make sure to strip enough length to fit into a butt connector.
Step 8: Bundle each 22 AWG wire with their corresponding color. (Red with red, blue with blue, ect.)
Step 9: Slide all 22 AWG (same colored) (4 Blue, 4 Red, 4 Black, 4 Green) wire into one end of a butt connector and crimp with a set of crimpers. (All red wire in one connector, all blue wire in one connector, ect.)
Step 10: Grab the 4-pin EZ connector (match with corresponding colored EZ connector) with the stripped ends of the RGB wire. Strip more of the outer jacket off each individual wire and feed each wire into the corresponding-colored butt connector. Crimp each butt connector end.
Do Not Return This Product!
NEED HELP?
– Call Us 480-616-2299
– Email Us: info@utvstereo.com
– Go To Product Page On Our Website & Watch Instruction Videos
Documents / Resources
 |
UTV Stereo Powersports RGB LED Controller Kit [pdf] Instructions Powersports RGB LED Controller Kit, Powersports, RGB LED Controller Kit, LED Controller Kit, Controller Kit, Kit |
