Othai 550ml Aroma Diffuser
USER MANUAL
PRECAUTION
Please check below to avoid malfunction of the unit:
- Do not fill over 550ML “MAX”at any time.
- Do not switch on power when the tank is empty.
- Do not touch the Ultrasonic vibration plate.
- Clean regularly as per Maintenance instructions to avoid malfunction.
- Always unplug from power supply before maintenance.
- For hygiene reasons, after use, pour away remaining water from “DRAIN SIDE” of tank, and wipe with a clean dry cloth.
- Essential oils can stain, In the event of spillage of contact, please wipe away with a soft cloth.
- Only use the measuring cup (not provided) to add water into the tank, do not fill water directly from the water pipe.
- Do not let mist below onto furniture, clothing, walls etc.
- Keep away frOm directing sunshine heat sou?ces and air conditioners or fans.
- Always keep on stable plat surface do not place on carpet, duvet or unstable area.
- Keep away from electronic equipment, such as TV and Auto equipment.
- Do not tip the product this may cause water to enter the mechanism and cause malfunction.
- Product use time: 8 hours
- Wait 60 minutes before restart to avoid damage to Ultrasonic plate.
- Use tap water only, does not use mineral water, sparkling water etc.
- Never move product in use.
- Do not touch any part of the product with wet hands.
- Keep out of reach of children and pets, Children not being supervised are suggested not play with the product. Appliance is not suitable for children or person with reduced physical, sensory or mental capabilities, or lack of experience and knowledge to be used, unless they have been given supervision or instruction.
- Keep cord clear of pathways, and do not pull forcefully at any point.
- If smoke or burning smell is detectd,unplug immediately.
OVERVIEW

OPERATION

1. Keep product straighten, remove the upper lid and water cap vertical direction. Fig1
2. Please connect the AC adaptor to the base of DC jack of the main body via cable guide. Fig2
3. Please use the measure cup(not included in the package) to supply water(Oo Not add high temperature water) from the water pipe,pay attention to the filled water1evel;do not exceed the max line.Please do not add water when the product is wor1cing.Drop essential oil into .water tank vertically.Flg3 4.lnstall the cover of the main body with the original
channel, To fall to the vertical direction, Rotate the cover to adjust the desired position mouth spray.
BTW: You must cover the upper cover when you want to use the product. Flg4
5. Please connect the AC adaptor with family user power supply socket.
6. Press”MISrbutton,choose the time needed, (1 H,3H, 6H or ON continuous spray time).MMIST”button ptease pressMMISrbutton five times (from 1H.3H,6H, ON to OFF).Flg5
7. Press •1ight”button to tum on the LED light.seven light color option at varying brightness are available.Fig6
8.lf you do not use it for a long time, please drain out the water from tank water, dry and then keep it well. If you want to use it again, please use the neutral detergent to clean the water tank again, then you can use it.
9. When the power is switched on, the initi?I state of Aromatherapy machine is turned off.
10. If lack of water in the tank, even though the MIST switch, aromatherapy machine will automatically tum off.
11. Mist and light off automatically when water runs out.
PRECAUTIONS
- Product use time: 8 hours
- The amount and intensity of mist produced will vary, but this is not unusual and should not be considered as a fault.
- Factors that affect this include water type,humidity,temperature,air currents.
- Auto power off when water runs out.
- Applies only 100% natural essential oils, if they contain chemical ingredients, flavors or impurities may cause damage to the product.
- Before replacing another essential oils, follQw the maintenance part of the clean-up products.
ACCIDENTAL LEKAGE
In the event of the unit being knocked over or tipped during use, please follow the steps as below to avoid malfunction:
1. plug the unit and remove cover.
2. pour out any remaining water from the water tank.
3. shake the unit gently to drain water.and then keep it natural air drying for at least 24 hours.

Remote Instruction

1. Power ON/OFF
2. Intermittent Mist
- 10 Seconds ON/
- 10 Seconds OFF/
3. Continuous Mist
4. Set Mist Timing according to Diffuser settings
5. High Mist/ Low Mist
6. Light ON/OFF/Varied Change Color
Maintenance and Cleaning
It is a good idea to clean the Diffuser after using for few days.
1. Unplug diffuser from the outlet.
2. Empty any remaining water from tank.
3. Clean tank using a small amount of dish soap or diluted white vinegar.
4. Wipe out and let dry.
MAINTENANCE
After using 8-10 times, or 3-5 days, please clean the product as follow:
1. unplug the unit from mains supply and remove cover.
2. pour out any remaining water from the tank.
3. add a small amount of warm kitchen detergent remover and water.use swab to wipe it gently.and then use cleaning cloth to dry it lightiy.
4. refer to the following pictures, to avoid water flow into the air outlet.pour off water abide by the left picture, not the right one.
5. do not use other acids or enzymes detergents.as this may give off poisonous gas or cause malfunction.
Note: Be sure to use a mild detergent.

TROUBLESHOOTING
Please refer to the table below in the event of the product operating abnormally:
| If product doesn’t w011< well, please refer to the following points before requesting repairs: | |
| Will not switch on or switch off | • Is there enough water in the tank? –Please add water to the tank • Is the power cord connected property? – Please disconnect, check cables and re-connect carefully. |
| No mist or abnormal mist | • Not enough water? or too much water? –Please add suitable afl)Ount of water in the tank, water must never be filled over 550ML (MAX?ine. • Dirt on the ultrasonic plate? –Please refer to maintenance instructions remove and re-install correctly, so vapors can be released freely. • Cover and inner cover are not installed property? Dirt on the air suction port on the underside of the base? –If too much dust in the air suction port, the mist will be restricted to come out.Just clean it. |
| Water leakage from product | • Cover and inner are not installed property? –Remove and reinstall correctly, so vapors can be released freely. • Low temperature or high humidity? – Under these conditions, the mist may condense quickly into water droplets. |
Documents / Resources
![]() | 550ml Aroma Diffuser |
References
- User Manualmanual.tools
