ORACLE LIGHTING 3018 TRIGGER Remote Momentary Switch Kit

Oracle Lighting

Oracle Part 3018

Trigger Momentary Switch Installation Guide

Tools Needed

• Flat Head Screwdriver

Installation Steps

1. Use a flat-head screwdriver to depress the tab on the side of the switch that you wish to change/replace.
2. Remove the switch.
3. Place the included spring over the post on the new switch.
4. Press the new switch back into your remote.

Specifications

Company	Oracle Lighting
Website	www.oraclelights.com
Address	4401 Division St. Metairie, LA 70002
Technical Support	1(800)407-5776

FAQ

• What tools are required for installation?
  A flat head screwdriver is required.
• Where can I find technical support?
  You can call 1(800)407-5776 for additional technical support.
• What is the first step in replacing the switch?
  Use a flat-head screwdriver to depress the tab on the side of the switch you wish to change or replace.

Documents / Resources

ORACLE LIGHTING 3018 TRIGGER Remote Momentary Switch Kit [pdf] Installation Guide 3018 TRIGGER Remote Momentary Switch Kit, 3018, TRIGGER Remote Momentary Switch Kit, Remote Momentary Switch Kit, Momentary Switch Kit, Switch Kit

References

• User Manual