Built-In Module Square
USER MANUAL
Mounting instructions
1 |
1. Cut off the electricity. |
2 |
2. Cut the ceiling according to the product ceiling cutout diameter size. |
3 |
3. Connect the driver to the power cable Connectfixturetothedriver. Make sure that the product is connected safely. |
4 |
4. Push the springs upward into the hole and release it. |
5 |
5. Fixtures are ready to use. |
 |
 |
 |
 |
 |
| 3W | 6W | 12W | 18W | 24W |
 |
 |
 |
 |
 |
| 3W 2431 2432 2433 2444 2445 2446 |
6W 2434 2435 2436 2447 2448 2449 |
12W 2437 2438 2439 2450 2451 2452 |
18W 2335 2440 2336 2348 2349 2453 |
24W 2441 2442 2443 2454 2455 2456 |
INSTALLATION INSTRUCTIONS
The installation of the luminaire must be performed by a qualified technician. Supply voltage of the light: 230V/50Hz
- Before you begin the installation, make sure the power is off.
- Connect the terminals of the input voltage of the power supply to the power cord from the mains.
- Insulate connections to prevent short circuits
Prima Group 2004 Ltd. is not responsible for damage caused by improper installation. This product complies with the following EU Directives:
– LVD 2014/35/EU
– EMC 2014/30/EU
IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1,
bI. 144, Ground Floor; Phone: +359 2 988 45 72;
Documents / Resources
 |
OPTONICA LED Built-In Module Square [pdf] User Manual LED Built-In Module, LED Module Square |
