OPPLE 10W-830 LED Linear Java Instruction Manual
OPPLE 10W-830 LED Linear Java Instruction Manual

LED LINEAR LIGHT

Itam Code cct Weight Trolley
521028003000 3000K/4000K 0.7Kg
Model Name L
(mm)
D
(mm)
H
(mm)
Rated
Voltage (V-)
Frequency
(Hz)
Current(A) Power Factor Rated
Power(W)
LED Linear-Java L580-10W 580 72 66 220-240 50/60 0.3 0.9 10

LED LIGHT

Product Code Product Description N Light source code QR Code Energy Label
521028003000 LED Linear-Java L580-10W-830/840-WH 1 LS118001032 QR Code  C

This product contains a light source of energy efficiency class (C).

Safety Instructions

To ensure correct function and safety, please read and follow all instructions carefully before using the product:

  1. Turn off power supply before installation or before doing any maintenance work.
  2. Do not install any luminaire near the heat source. nominal supply voltage or amperage ratings.
  3. Do not exceed the
  4. All wiring and installation of the light fitting must adhere to local and national wiring rules.
  5. Take care not to pull any electrical wires during unpacking as this may damage the connection.
  6. Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
  7. To avoid injury or damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
  8.  Please keep instructions for future reference.
  9. Please refer to IP(Ingress Protection) rating of this luminaire when deciding the location. of installation.
  10. If luminaire is exposed to high corrosive environment(coastal region), it will require a higher durability of powder coat, consult manufacturer before installation.

Installation Procedure

WARNING

INSTALLATION PROCEDURES
Tum Off Power Supply
Electrical shock Icon

  1. Switch off before installation.
  2. Switch on only after complete installation and examination of the circuit.
  3. Professional electrician for installation and maintenance only.

Waterproof Installation Tips(If applicable

Waterproof gasket for screwing Waterproof Installation Fasten the waterproof gasket into the mounting screws to prevent water from leaking inside.
Waterproof grommet for cable entry Waterproof Installation If there is gap between cable and waterproof grommet, please fill it with water- resistant silicone caulk to prevent water from leaking inside.
Waterproof cable Gland for mains entry Waterproof Installation Ensure that the waterproof cable gland is tightened to prevent water from leaking inside
Water-resistant silicone caulk in knock out hole Waterproof Installation Caulks in knock out holes are tight enough to avoid dust, insects, and especially water from leaking inside.

Wall mount installation

Waterproof Installation
select preferred colour temperature for product in CCT change function only.Waterproof Installation

Waterproof Installation
Waterproof Installation Neutral
Waterproof Installation Earth
Waterproof Installation Switched

Wire diameter: 0.5-2.5mm
Wire stripping length: 8-10mm

Waterproof Installation

Waterproof Installation

Waterproof InstallationIconOPPLE  Logo

Documents / Resources

OPPLE 10W-830 LED Linear Java [pdf] Instruction Manual
10W-830, 10W-840, 10W-830 LED Linear Java, 10W-830, LED Linear Java, Linear Java, Java

References

Leave a comment

Your email address will not be published. Required fields are marked *