INSTALLATION MANUAL

7872

230V | COB LED | 480LEDs/m | 12W/m | IP66

Supplied in 50m roll with double face adhesive tape. Avoid direct sunlight. Supplied with power supply EU plug and lm cable.

1. Cut every 10cm (48-LED segment)
2. 12mm

A. CUT:
The LED strip can be cut every 10cm (48-LED segment) at the clearly marked positions. Cut carefully at the desired length by using a sharp pair of scissors.
B. SEAL:
To seal the non-powered end of the LED strip, use the end cap 7872E. Fill the end cap with silicon glue and carefully place the filled cap on the end of the LED strip.
C. CONNECT:
To connect together two pieces of LED strips, use the accessory 7872C.
D. INSTALL:
Remove the 3M double face adhesive tape from the LED strip gradually during installation and fix into the required position.

Warnings:

1. The mounting surface must be clean, dry and free from dust or grease.
2. Make sure that the product is installed properly before connecting to electricity.
3. Do not bend, fold or twist the LED strip.
4. Do not bend to install in corners.
5. Do not put excessive pressure on surface of LED strip.
6. Do not cover LED strip with any materials.
7. Do not install in ambient temperatures below -10°C or exceeding 45°C.
8. Always handle the LED strip with care.
9. The LED strip should not be exposed to direct sunlight.
10. LED strips with different batch numbers may have slight variations in colour consistency (CCT±150K).
11. Maintenance and installation should only be carried out by a professional electrician.

www.1-light.eu

Documents / Resources

one LIGHT 7872 Flex Light line [pdf] Installation Guide 7872 Flex Light line, 7872, Flex Light line, Light line, line

References

• User Manual