Old shark WA-LAPMIC2P limited Device Database User Manual
Introduction
Thanks for choosing our product.
This product is a smart wireless microphone that provides professional-grade recording output. Plug and play, no app required. Multiple uses: It can be used in online live broadcast, video Vlog shooting, program interview, recording, video teaching and other occasions.
This product consists of three parts: charging box, microphone transmitter and receiver
(as shown in the figure below, some models have no charging box, Based on the actual object)
- Charging box
- Microphone transmitter
- Receiver
ID Diagram
- Windproof Net
- Connection indicator light
- Mute indicator light
- Noise reduction indicator light
- Battery indicator
- Microphone Type-c charging port
- Microphone clip
- Power on/off/mute button K1
- Function button K2
- port to connect phone
- port of receiver
- Indicator light
- Charging box Type-C charging port
- Charging box indicator
How to use
Step 1: Long press the power button on the microphone, and the connection indicator light will flash, indicating successful power on.
Step 2: Connect one end of the receiving end to the phone interface.
Step 3: The indicator light for the connection between the receiver and transmitter remains on, indicating a successful connection. Open the camera live streaming app on your phone and use the microphone to listen.
Note: oppo/vivo/iqoo/realm brand mobile phones can be used normally only when they go to the settings (search “OTG” – turn on OTG power supply)
About UI
Microphone Transmitter
| Function | Button | LED |
| Power on | Long press the 35 power button | Connection indicator light flashing slowly |
| Power off | Long press the 35 power button | All lights are off |
| Noise reduction | Click on the function key K2 | Noise reduction on: Theis erettiction light is on Noise reduction off: Thuiseraduction light is off |
| Silent mode | Click the power button K1 | Mute on: The mute light is on Mute off: Mute light off |
| Reverberation | Double dick the function kay K2 | Reverb on: Noise rededicating light breath ing fishes |
| Charging | When chagrin, the battery light is always red and on, while the fully charged light is off | |
| Low electricity | The battery level is below 20%. and the red light flashes sowed |
Receiver
| Function | Operate | LED |
| Connect 1 microphone | The left light stays on, and the right light flashes for 15 seconds before turning off | |
| Connect 2 microphone | Both the left and right lights are constantly on at the same time |
Packing List
Content of packing
- Microphone transmitter
- Lightning receiver
- Charging box
- Charging cable
- User manual
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Symbols
Documents / Resources
 |
Oldshark WA-LAPMIC2P limited Device Database [pdf] User Manual 2A2HV-WA-LAPMIC2P, 2A2HVWALAPMIC2P, WA LAPMIC2P, WA-LAPMIC2P limited Device Database, WA-LAPMIC2P, limited Device Database, Device Database, Database |