How to Sync Two Bases
CU170
- Plug both bases into a power source.
Operate each base with its respective remote control to verify the base functions properly.
NOTE
Make sure both remotes are in “press & hold” mode before beginning procedure - Lower both bases to the flat position and unplug them from outlet.
- Place both bases on their sides close to each other.
CAUTION:
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE THE ADJUSTABLE BASE. - Locate the sync cable.
- Unplug the underbed light plug from the MFP of the control box on both bases, then insert one male plug of sync cable into the MFP of base 1 control box and the other male plug of sync cable into the MFP of base 2 control box.
- Insert the underbed light plug from base 1 into one female plug of the sync cable, then insert the underbed light plug from base 2 into the other female plug of the sync cable.
- Turn both bases over onto their legs.
CAUTION:
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE. - Plug both bases back into power outlet.
- Operate the remote control(s) to verify both bases function in unison. If using only one remote control to operate both bases, store the second remote for use as a spare.
NOTE
If bases do not operate in unison with the remote, verify dual sync cable connections are fully seated in both MFP ports. Unplug both bases, wait 10 seconds, then plug them back in.
292-0041-D EDR 16023 4/21
Documents / Resources
 | CU170 Control Unit |
References
- User Manualmanual.tools
Published: December 11, 2021
Updated: December 12, 2021
I bought a used Okin bed. Unfortunately, there is no remote control for it, only a receiver ECO basic 90410. And it comes with a 1 and 9 volt block. I have the series no also E590073361277. Unfortunately, I can’t find any instructions for the bed on the internet either. Could you please help me further.
Kind regards
phle
Ich habe mir gebraucht ein Okin Bett gekauft. Es ist leider keine Fernbedienung dazu nur ein receiver ECO basic 90410. Und es ist ei und neun volt Block dabei. Ich habe die Serie no auch E590073361277. Ich finde leider auch keine Anleitung zum Bett im Internet. Könnten Sie mir bitte weiter helfen.
Mit freundlichen Grüßen
Pehle
Kind regards
phle<e/em>
Ich habe mir gebraucht ein Okin Bett gekauft. Es ist leider keine Fernbedienung dazu nur ein receiver ECO basic 90410. Und es ist ei und neun volt Block dabei. Ich habe die Serie no auch E590073361277. Ich finde leider auch keine Anleitung zum Bett im Internet. Könnten Sie mir bitte weiter helfen.
Mit freundlichen Grüßen
Pehle
How can I find instructions and a replacement remote for an Okin bed with an ECO basic 90410 receiver?
Based on the information provided, you are looking for support for an Okin adjustable bed system using the ECO basic 90410 receiver. While the manual on this page is for the CU170 Control Unit, Okin systems often share similar pairing procedures.
For the ECO basic receiver, please try the following general steps to pair a new remote (if you obtain one):
Since you are missing the remote entirely, we recommend contacting Okin Refined or Leggett & Platt (the manufacturer listed on related CU170 documentation) with your serial number (E590073361277) to identify the exact compatible wireless handset. You can also search for "Okin ECO basic replacement remote" on specialized adjustable bed part websites.
Read the full Q&A page