
Mounting Base Installation Instructions
Toyota Tundra 2007-2013
Toyota Sequoia 2008-2022
COMPONENTS
01. Using the L-key provided, slightly loosen the screw to ensure the inner plate moves.
Do not fully remove the screw – keep about one thread engaged.
02 A. For this install, you will be utilizing the tab on the inner base plate and the seam between the dash and air vent.
02 B. Slide the tab of the inner mounting base plate into the seam between the dash and air vent (01). Then rotate the mounting base counter clockwise until the full tab of the inner plate rests in the corner as shown (02).
03. Using the L-key, hand tighten the screw until the mounting base has a snug fit.
To ensure the best fit possible, hold mounting base while tightening.
POSITIONING
Fits in the areas as shown.

WARNINGS
- Do not mount accessories in front of or near the path of airbag deployment.
- Check vehicle compatibility before install to avoid damage to the vehicle mount point.
- Designed to work with OEM dashboard only, not compatible with aftermarket modifications.
- Do not use with 3rd party extension arms. Adhere to our phone weight limits.
- Mount electronics away from airflow to prevent heat damage.
Self-installation instructions and advice are provided for your convenience. It is your responsibility to determine if you have the knowledge, skills, and physical ability required to properly perform an installation. Offroam shall have no liability for damage or injury resulting from the installation or use of any Offroam or third party products. It is your responsibility to ensure that all products are installed in adherence with local laws and regulations and in such a manner as to allow a vehicle to be operated safely and without distraction. Offroam product warranties do not cover the installation, removal or re-installation of any product.
WATCH THIS INSTALL
https://offroam.com/toyota-tundra-2007-2013/install-video
Documents / Resources
![]() | 2007-2013 Mounting Base |
References
- User Manualmanual.tools
