Syspend
Sanitary HMI Fixed Coupling
Instruction Manual
SFCSS Syspend Sanitary HMI Fixed Coupling
NOTE: Cutout template must be printed at 1:1 scale. Measure after printing to verify dimensions.
 |
 |
| a. Install tube/sleeve into fitting. Be sure safety screw is fully seated in fitting cutout. b. Push sleeve down into fitting until it is tight. c. Be sure top surface of sleeve is aligned at split, or left side is lightly lower than right. d. Place o-rings in position dry. |
Lube top surface only of both o-rings (the surface the nut will contact) |
5. Tighten nut slowly and watch for any part movements that may pitch the o-ring.
© 2019 Hoffman Enclosures Inc.
PH 763 422 2211
nVent.com/HOFFMAN
89042837
Documents / Resources
 |
nVent HOFFMAN SFCSS Syspend Sanitary HMI Fixed Coupling [pdf] Instruction Manual P-N 89042760, 89042837, SFCSS, SFCSS Syspend Sanitary HMI Fixed Coupling, Syspend Sanitary HMI Fixed Coupling, Sanitary HMI Fixed Coupling, HMI Fixed Coupling, Fixed Coupling, Coupling |