ANMV6 Large Ventilator
Instructions
Large Ventilator
ANMV6 Large Ventilator
- Use the ventilator as a template and position on enclosure side, .188 inches from all edges.
- Mark the enclosure through the centermost, square, vent hole and the three mounting holes.
- Drill a 1.125 inch diameter hole in the enclosure as shown in Figure 1.
- Drill three .156 inch diameter holes as shown in figure 2.
- Bend the ventilator closed as shown in figure 3 and 4. Install the gasket (item A) in place with the sealing washers (item B) and mounting screws (item C). Finally, screw ventilator to the enclosure. (Figure 4)
Rev. C
© 2019 Hoffman Enclosures Inc.
PH 763 422 2211 • nVent.com/HOFFMAN
P/N 99401091
87568875
Documents / Resources
 |
nVent HOFFMAN ANMV6 Large Ventilator [pdf] Instructions ANMV6, ANMV6 Large Ventilator, Large Ventilator, Ventilator |