Nutale F20X Smart Tracker User Manual

Use of the Works with Apple badge means that a product has been designed to work speciﬁcally with the technology identiﬁed in the badge and has been certiﬁed by the product manufacturer to meet Apple Find My network product speciﬁcations and requirements.

Apple is not responsible for the operation of this device or use of this product or its compliance with safety and regulatory standards.
Apple, Apple Find My, Apple Watch, Find My, iPhone, iPad, iPadOS, Mac, macOS and watchOS are the trademarks of Apple Inc., registered in the U.S. and other countries. IOS is a trademark or registered trademark of Cisco in the U.S. and other countries and is used under license.

To use the Apple Find My app to locate this item, the latest version of iOS, iPadOS, or macOS is recommended. The Find Items app on Apple Watch requires the latest version of watchOS.

Instructions for device button

Power on
After installing the battery, long press the button for ﬁve seconds, the device will beep, the light will ﬂash three times, and the device will be turned on.

Device status conﬁrmation
Double-click the device button, the device will beep, and the light will ﬂash three times, indicating that the device is working. If the device does not ring, the device is oﬀ. Long press the button for ﬁve seconds to turn it on.
The device enters the pairing state again
After removing the device in the app, the device will beep and the light will ﬂash six times, it will not shut down and will be in the pairing mode. If there is no re-pairing within 10 minutes, the device will leave the pairing state. If you want to pair a device at this time, you need to click the device button once, the device will beep, and the light will ﬂash once.At this time, the device enters the pairing state and can be paired with the app again.

Factory Reset
First, remove the item from Find My app, then, after the device is powered on, double-click the device button. The device will beep. Long press the device button for eight seconds until the device beeps and the light ﬂashes three times. Release the button to complete factory reset. The device can now be paired.
Power oﬀ
When the device is on, press the device button 5 times in 2 seconds. The device will beep, the light will ﬂash three times, the device will be powered oﬀ.

Regulatory Safety Information

WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN

Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed or inserted a button battery, immediately call the 24-hour Poison Information Centre for fast expert advice.

Rated voltage 3V

Rated curent~15mA

Immediately dispose of used batteries and keep away from children.

Do NOT dispose of batteries in household trash. Even used batteries may cause severe injury or death.
Call a local poison control center for treatment information.

KEEP BATTERIES OUT OF REACH OF CHILDREN Keep in original package until ready to use Call a local poison control center for treatment information.
Australia: 13 11 26 Canada: 1-800-268-9017(Ontario), 1-800-567-8911(BC), 1-800-463-5060 (Quebec) US: 800-498-8666.Verify suitable. emergency call numbers for your country.

Do not use if the compartment is not secure. Dispose of used button batteries promptly and safely. Flat batteries can still be dangerous.

European Union-Disposal Information The symbol above means that according to local laws and regulations your product and/or its battery shall be disposed of separately from household waste. When this product reaches its end of life, take it to a collection point designated by local authorities. The separate collection and recycling of your product and/or its battery at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment.

Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate.
Even used batteries may cause severe injury or death.
Call a local poison control center for treatment information.
Battery type : CR2032.
Nominal battery voltage :3 V.
Non-rechargeable batteries are not to be recharged.
Do not force discharge, recharge, disassemble, heat above60 °C or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
Ensure the batteries are installed correctly according to polarity (+ and -).
Remove and immediately recycle or dispose of batteries from equipment not used for an extended period of time according to local regulations.
Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.
Do not mix old and new batteries, diﬀerent brands or types of batteries, such as alkaline, carbon-zinc, or rechargeable batteries．

Risk of fire and burns.

Do not recharge, disassemble, heat (-20°C +70°C)or incinerate.

Article 12
Without permission, any company, ﬁrm or user shall not alter the frequency, increase the power, or change the characteristics and functions of the original design of the certiﬁed lower power frequency electric machinery.

Article 14

The application of low power frequency electric machineries shall not aﬀect the navigation safety nor interfere a legal communication. if an interference is found, the service will be suspended until improvement is made and the interference no longer exists.
The foregoing legal communication refers to the wireless telecommunications operated according to the telecommunications laws and regulations.

The low power frequency electric machinery should be able to tolerate the interference of the electric wave radiation electric machineries and equipment for legal

communications or industrial and scientiﬁc applications.

Safety Statement

WARNING

INGESTION HAZARD: This product contains a button cell or coin battery.
DEATH or serious injury can occur if ingested.

A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours. KEEP new and used batteries OUT OF REACH OF CHILDREN.
Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

FCC Caution.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment oﬀ and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement.The device can be used in a portable exposure condition without restriction.

FCC ID: 2ADD5-F20X

Important tips：
When pairing a device with Find My app, the phone will link to the Apple server. Pairing may fail because of network problems. The following actions are recommended:

Change the phone’s network, such as switching between WiFi and mobile network.
Factory Reset for the device: When the device is powered on, double-click the device button.The device will beep, then immediately long press the device button for eight seconds until the device beeps for the second time and the indicator light ﬂashes. Release the button, Factory Reset is completed.
(Note: after long pressing the device button for 2 seconds, the device will sound “tick, tick, tick”, and the indicator light near the button ﬂashes. Do not release it. Continue to press and hold the button until the device emits a music for the second time, and the indicator light ﬂashes. Release the button).
Pair with Find My app.

Product overview

Battery compartment screws

WWW.NUTALE.COM

FAQs

1. How to Confirm Whether the Device has been Turned On?
Double-click the device button. The device will beep, and the light will flash three times, indicating that the device is working. If not, long press the button for five seconds to turn it on.

2. How to Replace the Battery?

Loosen the screws on the back of the device using a screwdriver.

Knock open the outer shell using a thin sheet.
Remove the old battery and install a new button battery with the positive pole facing up.
Install the back cover, tighten the screws, and press and hold the power button for 5 seconds to turn it on.

Documents / Resources

Nutale F20X Smart Tracker [pdf] User Manual
F20X, F20X Smart Tracker, F20X, Smart Tracker, Tracker

References

User Manual

Nutale F20X Smart Tracker

Product Usage Instructions